Advanced Semiconductor Engineering Chung Li Branch SCLCT06M Bluetooth Headset User Manual
- June 6, 2024
- Advanced Semiconductor Engineering Chung Li Branch
Table of Contents
Advanced Semiconductor
Engineering Chung Li Branch SCLCT06M Bluetooth Headset
User Manual
SCLCT06M User’s Manual
Power ON/OFF
Turn on: press the button -> You will hear “POWER ON” when powering on
(the left and right ears should be turned on separately)’
Turn Off: You must disconnect the device or mobile phone before turning
off -> Press and hold the button to hear “Beep~Beep Beep”, then release to
hear power off
How to repair:
Our headset will remember the phone or device.
To connect with the new device -> Make sure you hear power on -> Press and
hold the button and you will hear “Beep~BeepBeep~ BeepBeepBeep” and then
release it to find it on the phone.
Speaker
Driver unit:30mm, dome type(CCAW Voice Coil)
Impedance: 24ohm at 1kHz
Sensitivity:98dB/mW
Frequency response:10Hz-24000Hz FCC Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End-user must follow the specific operating
instructions for satisfying RF exposure compliance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>