DURASHOCK UB12F3F Modular Universal Rubber Bump Stops Instructions
- June 1, 2024
- DURASHOCK
Table of Contents
DURASHOCK UB12F3F Modular Universal Rubber Bump Stops
Technical Specifications
- Product Name: Modular Universal Bump Stop
- Model: Sample-Modular Model
- Test Requested: Test Speed
- Load at 50% compression (Single): 15.44 kN / 3,471 lbf
- Load at 50% compression (Pair): 30.88 kN / 6,942 lbf
- SGS Visual Observation: No damages observed
Product Usage Instructions
Installation Requirements
Ensure common automotive safety practices during installation. It is
recommended to have professionals with mechanical knowledge perform the
installation to prevent incorrect or faulty installations.
Installation Steps
- Identify the correct placement for the Modular Universal Bump Stop.
- Securely install the bump stop following the manufacturer’s guidelines.
- Ensure proper alignment and tight fastening to prevent any issues during usage.
Usage Guidelines
Operate the vehicle within recommended load limits to maintain the
effectiveness of the bump stop. Regularly inspect the bump stop for any signs
of wear or damage and replace if necessary.
Maintenance
Periodically check the bump stop for wear and tear. Clean any debris that
may accumulate around the bump stop to ensure proper functionality.
Troubleshooting
If you experience unusual vehicle behavior or noise, inspect the bump stop
for any visible damage or misalignment. Consult a professional if needed.
FAQ
-
Q: How often should I inspect the bump stop?
A: It is recommended to inspect the bump stop during regular maintenance checks or whenever you notice any changes in vehicle performance or ride quality. -
Q: Can I install the Modular Universal Bump Stop myself?
A: While it is possible to install it yourself, it is advisable to have professionals with mechanical knowledge perform the installation to ensure proper fitting and functionality.
Modular Universal Bump Stop Technical Report
- WARNING: Common automotive safety practices are required during installation. Professionals with mechanical knowledge are recommended. Durashock is not responsible nor be held liable for incorrect or faulty installations.
- All reports are based on a single unit. The loading will double if both products are placed at one end.
Technical Specifications
| Sample-Modular Model | UB12F3F (UB1+UB2F+UB3F) |
|---|---|
| Test Requested | Load Compression at 50% |
| Test Speed | 0.8 in/min |
| Load at 50% compression (Single) | 15.44 kN / 3,471 lbf |
| Load at 50% compression (Pair) | 30.88 kN / 6,942 lbf |
| SGS Visual Observation | No damages observed. |
UB12F3F Compression Test by SGS Lab
www.dura-shock.com E-mail: info@dura- shock.com Tel: 562-287-4973