choetech T315 2-in-1 Portable Power Bank for Apple Watch User Manual

: June 6, 2024
: CHOETECH

Table of Contents

Package Content
Specifications
Product Diagram
Check the Power Level
Charge Your Apple Watch via the Charging Dock
Charge Your Apple Watch and USS Device
Two Ways to Recharge the Power Bank
Attention
Important Safety Instructions
FCC Compliance Statement
Warranty
Read User Manual Online (PDF format)
Download This Manual (PDF format)

choetech T315 2-in-1 Portable Power Bank for Apple Watch

Package Content

1 x Portable Power Bank for Apple Watch
1 x Charging Dock with USB Cable (Attached 38mm Foot Pads)
2 x Silicone Pads (38mm and 42mm)
1 x User Manual
1 x Customer Service Card

Specifications

Capacity	S000mAh
Micro USB Input	5V/2A (Max)
USB-A Output	SV/2.1A (Max)
Magnetic Charging Module for Apple Watch	5V/1A (Max)

Product Diagram

Check the Power Level

Charge Your Apple Watch via the Charging Dock

Put the power bank in the charging dock and connect to power –Put your Apple Watch on the magnetic charging module to charge.

Charge Your Apple Watch and USS Device

Press and hold the power button for 3 seconds to turn on the power bank-Charge your Apple Watch and charge your USB device simultaneously.

Two Ways to Recharge the Power Bank

Recharge via the charging dock

Recharge via a Micro USB cable (not included)

Attention

To charge a device via the USB output, a USB cable (sold separately) is required.
To rechage the power bank via the Micro USB input, a Micro USB cable (sold separately) is required.
Press and hold the power button for about 3 seconds to turn on/off the power bank.
When you charge the power bank or charge your devices via the power bank, the white LED indicators lights will stay on all the time, and the LED lights will turn off in 6-8 minutes after you cut the power off.

Attention
Internal battery poses risk of fire and burns. Do not disassemble, crush, heat above 60 t:/140°F or incinerate.
Follow manufacturer’s instructions.

Important Safety Instructions

When using this product, basic precautions should always be followed, including the following:
a) Please read all instructions before using the product.
b) To reduce the risk of injury, close supervision is necessary when the product is used near children.
c) Please do not insert fingers or hands into the product.
d) Please do not expose power bank to water (ex. rain) or cold temperat ures (snow).
e) Using a wall charger not recommended or sold by power bank manufacturer may pose risk of fire or inj ury.
f) Please do not use the power bank in excess of its output rating. Overload outputs above rating may result in a risk of fire or inJury to persons.
g) Do not use the power bank if it is damaged or altered. Damaged or altered batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
h) Please do not disassemble the power bank. Please seek only authrozied service providers when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
i) Do not expose the power bank to f ire or excessive temperature. Exposure to fire or temperat ure above 100°C (or 212 °F) may cause explosion.
j) To ensure product safety, please have product serviced by a qualified repair person using original manufacturer’s replacement parts.
k) Please be sure to switch off the power bank when not in use.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference .
(2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.