nordlux Scorpius Outdoor Wall Light Instruction Manual
- June 6, 2024
- nordlux
Table of Contents
bulb not included
BOWLER
Mounting Instruction
IP5X: Dust is prevented from entering the lamp in amounts that
function/safety of the lamp.
IPX4: Raindrops falling from any angle will not affect the can cause
damage to the function/safety of the lamp.
Class
I: The lamp has an earth terminal and must be connected to the yellow/green
earth wire.
The
lamp is only suitable for connecting directly to the mains.
MAX60W
Do not exceed the maximum wattage.
The
lamp is only suitable for fixing to the wall.
The
heat-resistant sleeves must be attached to the unstripped wire lengths.
The mounting instruction must not be discarded.
IMPORTANT! Always shut off power to the circuit before starting
installation work. In some countries electrical installation work may only be
carried out by a authorized electrical contractor. Contact your local
electricity authority for advice.
Parallel arranging possible.
In Denmark, outdoor lighting must be mounted by an authorized electrician.
We congratulate you on your new outdoor lamp!
We congratulate you on your new outdoor lamp
Stainless steel
Remember to take care of your lamp. Just follow the guidelines below.
The shiny, uniform and the decorative surface of stainless steel makes it very
suitable for outdoor use. It is an alloy consisting of iron, chrome and
nickel. During bath pickling, a thin, rustproof oxide layer forms on the
surface. The surface is continually vulnerable to atmospheric conditions and
from other effects of the close environment. This means that the lamp must be
regularly maintained if its surface is to remain shiny and untarnished by
rust. Before setting it up, treat your lamp with acid-free oil, and dry it off
with a soft cloth. Repeat this three or four times a year. Stainless steel
clamps are not recommended for use in aggressive environments such as coastal,
agricultural or industrial areas.
Copper lamps
Our copper lamps are made of solid copper. The mechanical preparation leaves minor scratches in the surface which quickly disappears in connection with the patina process. After a few showers, the copper will get stained but the aerated air and moisture will soon make the lamp appear with a dark brown surface. The characteristic patina-green colour will first appear after several years, dependent on the environment, weather etc.
Hot-galvanized lamps
The zinc treatment of the steel lamps is executed manually in plants. The temperature of the melted zinc is about 460 degrees. When the lamps are dipped in melted zinc a reaction between the metals occurs, which develops alloys in the surface. The lamp and the components of the lamp are manually dipped in the hot zinc. This treatment leaves variations in the coating in the form of partly an uneven surface and partly minor formations of drops. Thin Dzinc curtains« might also occur on the surface and they show as a thin film that hangs down from the edge of the lamp. This film can easily be removed or brushed off with a soft brush.
Condensation
Condensation is a natural phenomenon arising under specific atmospheric conditions. Damp heat and cold air meet, which causes condensation of water on the surface. When water heats up it leads to rising water vapour, which will be able to affect electric components. Condensation is not included by Nordlux warranty unless it is possible to prove that a technical /production error in the lighting causes entry of water. In case of condensation please check:
- If the lighting is mounted according to instructions. Washers should seal tightly. Make sure to tension screws and lenses.
- In garden lightings rising damp from the ground may cause condensation in the metal post. This problem can be defeated by filling sealing material into the metal post.
- It is highly important that drainage holes are kept free of impurities if any.
BEFORE ASSEMBLING THE BOLLARD AGAIN DO REMEMBER TO WIPE OFF ALL PARTS!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>