EVGA X20-RX01 Wireless Gaming Mouse User Guide

X20-RX01 Wireless Gaming Mouse
User Guide

https://www.evga.com/qr.asp?ID=31967

GETTING START YOUR X20 GAMING MOUSE

STEP 1 Plug USB Charging/Data Cable to your PC, and the mouse will charge simultaneously
STEP 2 Turn on your PC
STEP 3 Install EVGA
STEP 4 Enjoy it!

INTRODUCTION

A Left-Click Key
B Right Click Key
C Middle Click Key
D Wheel Left Scroll
E Wheel Right Scroll
F Profile Cycle Key
G DPI Cycle Key
H DPI Indicator
I Side Front Key
J Side Rear Key
K Sniper Button

L Micro USB Port
M Lift Off Distance Detection Sensor 2
N Lift-Off Distance Detection Sensor
1 O Pixart 3335 Optical Sensor
P Connection Switch
Q Pairing LED
R Pairing Button
S USB Charging/Data Cable
T Extension Adapter
U USB Receiver

SETTING UP YOUR X20 GAMING MOUSE

2.4GHz Wireless Mode:
a. Plug the USB charging/data cable to the computer.
b. Use an extension adapter to connect the USB receiver and USB charging/data cable.
c. Turn the connection switch to the ” 2.4G” position.
d. The Pairing LED on the mouse will turn solid green while connected.
Bluetooth Wireless Mode:
a. Turn on a Bluetooth-enabled computer and initiate Bluetooth pairing mode.
b. Turn the connection switch to the” ” position.
c. Press the pairing button on the mouse for 5 seconds and the pairing LED on the mouse will start blinking green.
d. The Pairing LED on the mouse will turn solid green while connected.
Sniper Button:
This allows you to change DPI to 400 (Default value) when held. LOD
Sensors:
X20 Mouse is equipped with two LOD sensors. You can calibrate each LOD sensor with EVGA Unleash Software.

SETTING UP YOUR X20 GAMING MOUSE

LED Indicator:

SETTING UP YOUR X20 GAMING MOUSE
LED Indicator :

Stage 2 – 1600 DPI
Stage 3 – 3200 DPI
Stage 4 – 6400 DPI
Stage 5 – 16000 DPI
Profile Status| Profile 1| LED – Red
Profile 2| LED – Orange
Profile 3| LED – Yellow
Profile 4| LED – Green
Profile 5| LED – Blue

TRADEMARK & COPYRIGHT INFORMATION

Trademark & Copyright Information
2000-2021 EVGA Corp. EVGA, the EVGA logo and combinations thereof are trademarks of EVGA Corp. All brand names, company names, service marks, logos, and trademarks of the company, or its affiliates or licensors are trademarks or registered trademarks of the company or its subsidiaries, affiliates or licensors in the US and other countries. Other companies, products, and service names may be trademarks or service marks of others. EVGA reserves the right to terminate this license if there is a violation of its terms or default by the Original Purchaser. Upon termination, for any reason, all copies of Software and materials must be immediately returned to EVGA and the Original Purchaser shall be liable to EVGA.com CORP for any and all damages suffered as a result of the violation or default.
Legal Information
All material including but not limited to, text, data, design specifications, diagnostics, graphics, logos, reference boards, files, images, drawings, and software including this document and the software itself (together and separately) is owned, controlled by, licensed to, or used with permission by EVGA Corporation and is protected by copyright, trademark, and other intellectual property rights. All is being provided “as is”, EVGA Corporation makes no warranties, whether express or implied, statutory or otherwise with respect to the materials and expressly disclaims all implied warranties of non-infringement, merchantability, and fitness for a particular purpose. In no event shall the liability of EVGA Corporation for claims arising from the use of the materials by anyone exceed the original purchase price of the materials (or replacement of the materials at EVGA Corporation’s option). All information furnished is believed to be accurate and reliable. However, EVGA Corporation assumes no responsibility for the consequences of use of such information or for any infringement of patents or other rights of third parties that may result from its use, or use of the Software. No license is granted by implication or otherwise under any patent or patent rights of EVGA Corporation except as expressly provided herein. All specifications mentioned in this publication are subject to change without notice.

COMPLIANCE INFORMATION

WEEK
This product must not be disposed of with your other household waste or treat in compliance with the local regulations or contact your local city office, your household waste disposal service or the shop where you purchased the product.
Warning: Do not expose batteries or battery packs to excessive heat such as sunshine, fire or the like.

COMPLIANCE INFORMATION

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End-user must follow the specific operating instructions for satisfying RF exposure compliance.
The products are compliant with SAR for general population/uncontrolled exposure limits in IC RSS-102 and has been tested in accordance with the measurement methods and procedures specified in IEEE 1528.
CE Compliance Information
Generic Radiation Interference Standard for Information Technology Equipment. (EN 55022: 2006, Class B), (EN 61000-3-2: 2006), (EN 61000-3-3: 1995 + A1: 2001 + A2: 2005). Warning: This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.Generic Immunity Standard for Information Technology Equipment. (EN 55024: 1998 + A1: 2001 + A2: 2003).
Industry Canada STATEMENT
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
Contact Information:
EVGA Corporation: 408 Saturn Street, Brea, CA 92821, USA
EVGA Miami: 1345 NW 98 Court, Bldg A, Unit #3, Doral, FL 33172
EVGA Gmbh: Am Haag 8, 82166 Gräfelfing, Germany
EVGA Taipei: 18F., No.176, Jian 1st Rd., Zhonghe
Dist., New Taipei City 235, Taiwan(R.O.C) :17618
TEL : +1.888.881.3842
TEL : +1.305.477.1252
TEL : +49.89.189.049.11
TEL : +886.2.82262868
TEL : +886.2.82262868

Product Information:

Gaming Mouse
Model//: X20
Rating//: 5V 500mA
Made in China
USB Receiver
Model//: X20RX
Rating//: 5V 100mA
Made in China
Model No. :
Gaming Mouse / : X20

| #3m7
---|---
(Pb)| (Hg) I| (Cd)| (Cr’)| (PBB)| (PBDE)
| 0| 0| 0| 0| 0| 0
| 0| 0| 0| 0| 0| 0
| X| 0| 0| 0| 0| 0
| 0| 0| 0| 0| 0| 0
SJ/T 11364
0:  GB/T 26572
X:  GB/T 2
“X”  RoHS IR ” 2011/65/EU

RoHS

Lead
(Pb)| Mercury
(Hg)| Cadmium
(Cd)| Hexavalent
Chromium
(Cr-)| Polybrominated
biphenyls
(PBB)| Polybrominated
diphenyl ethers
(PBDE)
| O| O| O| 0| O| O
| O| O| O| O| O| O
| | O| O| O| O| O
| O| O| O| O| O| O
Note 1： “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicates that the percentage content of the restricted substance exceeds the reference percentage value of the present condition.
Note 2：“○” indicates that the percentage content of the restricted substance does not exceed the percentage of the reference value of presence.
Note 3：The “−” indicates that the restricted substance corresponds to the exemption.

References

• EVGA - Intelligent Innovation - Official Website

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>