Alphalite HEBS-2 High Efficacy LED High Bay Instruction Manual

: October 27, 2023
: Alphalite

Table of Contents

Alphalite HEBS-2 High Efficacy LED High Bay
WARNING
Installation Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Alphalite HEBS-2 High Efficacy LED High Bay

Alphalite-HEBS-2-High-Efficacy-LED-High-Bay-PRO

WARNING

RISK OF FIRE OR ELECTRIC SHOCK
The HEB High Efficacy LED High Bay must be installed by a qualified electrician in accordance with applicable federal, state, and local laws and codes. Installation requires knowledge of luminaire electrical systems and installer should be familiar with the operation of this product. If not qualified, do not attempt installation; contact a qualified electrician. The manufacturer assumes no responsibility for the improper installation of this luminaire. When installing the fixture, drilling may damage luminaire wiring and electrical parts. Check for wiring and components in enclosure before drilling.

WARNING
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. When installing this kit, drilling may damage luminaire wiring and electrical parts. Check for wiring and components in enclosure before drilling.

CAUTION
RISK OF PERSONAL INJURY

Wear gloves or proper handling protection to prevent cuts or abrasions when handling and maintaining this product. This equipment may have sharp edges. To reduce the risk of death, personal injury or property damage from fire, electirc shock, falling parts, cuts/abrassions, and other hazards read all warning and instructions included with and on the fixture box and all fixture labels.
Avoid direct eye exposure to the light source while it is on.

WARNING
RISK OF PERSONAL INJURY, FIRE OR ELECTRIC SHOCK Turn OFF power before installation.

NOTICE

Green ground screw provided in proper location.Do not relocate.
Minimum 90° supply conductors.
Specifications and dimensions subject to change without notice.
Suitable for Dry or Damp location.

Installation Instructions

A: Cable Kit
B: Chain Kit
C: Wire Guards
D: Surface Mounting

Alphalite-HEBS-2-High-Efficacy-LED-High-Bay-4

Installation Step:

Always turn off the power supply from main circuit breaker first!

Remove the new LED fixture from packaging and inspect for any damages. Handle new LED fixture with care.
CHAIN MOUNT EXAMPLE; Install the chain into the provided wire hanger. Secure the other end of the chain to a structure using hardware rated for the load.Install the wire hanger onto the side of the top ETLB6 LED channel.
Make sure the wiring hangers are fully engaged into the side holes on the top channel.
Connect the LED high bay wiring to line wire, black to black, white to white and green to green. Use only UL listed wiring. **NOTE: Purple and grey lead inside the driver compartment are 0-10V (low voltage) dimming leads. Connect to dimming low voltage wiring only.
Clean all residues/fingerprints from the new LED high bay and lens. Double check all hanging hardware before moving onto the next installation.

WARNING: RISK OF PERSONAL INJURY Proper grounding of metal parts is required for safety

Wiring Diagram:

0-10V Dimmable Wiring
Follow the wiring directions as in fig. 1.

Connect the black fixture lead to the (+) LINE supply lead
Connect the white fixture lead to the (-) COMMON supply lead.
Connect the GROUND wire from fixture to supply ground. Do NOT connect the GROUND of the dimming fixture to the output.
Connect the purple fixture lead to the (V+) DIM lead.
Connect the gray fixture lead to the (V-) DIM lead.

ON-OFF Wiring
Follow the wiring directions as in fig. 1.