M5STACK BN 2306308 1-to-3 Hub Unit Instructions
- June 6, 2024
- M5STACK
Table of Contents
M5STACK BN 2306308 1-to-3 Hub Unit
Description
HUB is a unit that is used in order to expand the GROVE ports over the M5Stack device. For example, if we want sensors with different I2C addresses or output to 3 devices at the same time. (M5Stack device usually can output one device at a time to to limited amount of grove ports).
Notice: HUB is just a hardware expander, if you are looking for hardware and software (standard protocol) expander like I2C, Single-bus, please check PaHUB or PbHUB
If you are connecting two I2C slave devices onto HUB that share the same address, you will have problem getting I2C data from both. The I2C addresses of the devices must be different, they can be changed manually by changing the resistor values
Development Resources
Development resources and additional product information are available from:
Specification
- GROVE Expander
- Two Lego-compatible holes
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.At the end of its service life, dispose of the product in
accordance with applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection
of the environment.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>