AIR LIFT EBK83016 WirelessAIR Wireless Controller with EZ Mount Instructions
- June 6, 2024
- Air Lift
Table of Contents
AIR LIFT EBK83016 WirelessAIR Wireless Controller with EZ Mount Instructions
REPLACING BATTERY IN THE WIRELESS CONTROLLER
- To install or replace the CR123A battery in the wireless controller, remove the battery cover from the back of the wireless controller.
- Remove the battery by sliding the battery toward the spring with one hand and lifting the battery out with the other hand.
- Insert the battery with the negative side toward the spring in the wireless controller. Take note of the”-” and”+” symbols on the circuit board.
- Replace the battery cover. There will be an audible click when the cover is fully seated.
FCC AND INDUSTRY CANADA INFORMATION TO USER
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: Changes or modifications not expressively approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Remote
FCCID: 2ANLC-EBK83016
22
IC: 23130-EBK83016
Manifold
FCC ID: 2ANLC-HMK122713 IC: 23130-HMK122713