IMOU IPC-F22A Bullet Network Camera User Guide
- June 6, 2024
- imou
Table of Contents
IMOU IPC-F22A Bullet Network Camera
Packing List
- Camera x1
- Positioning Map x 1
- Waterproof Connector x 1
- Screw Package x 1
- QSG x1
Camera Introduction
The pattern of the LED indicator is included in the following table.
LED Indicator Status / Device Status
- Off Powered off/LED turned off
- The red light on Booting
- Device malfunction
- Greenlight on Operating properly
- Red light flashing Network connection failed
- Green and red lights flashing alternately Firmware updating
Application
Scene 1
Scene 2
About the Guide
- This quick start guide is for reference only. Minor differences might be found in the user interface.
- All the design and software here are subject to change without prior written notice.
- All trademarks and registered trademarks mentioned are the properties of their respective owners.
- Please visit our website or contact your local service engineer for more information.
- If there is any uncertainty or controversy, please refer to our final explanation.
Operating with I mou Life App
-
Step 1 Scan the following QR code or search “you Life” in Google Play or App Store to download and install the app.
Note: If you have installed the app, update ii to the latest version. -
Step2 Run more Life App and then register an account for the first use.
-
Step 3 Power up the camera, and when the booting is finished, the green light is on.
-
Step4 Add a camera to you Life App On the Device interface, tap + on the upper-right corner, scan the QR code on the bottom of the camera or enter the serial number, and do the operations as the screen instruction.
Note: If you have more than one camera, do step 4 to add them one by one.
Installing Camera
Note: Make sure that the mounting surface is strong enough to hold at least three times of the device weight.
- Step1 Drill screw holes on the mounting surface as the positioning map shows, and then put in the expansion bolts.
- Step2 Attach the pedestal to the mounting surface with the self-tapping screws.
- Step3 Power up the camera, and then adjust the lens to the ideal angle.
FAQ
- Q: The camera cannot work normally or start? Make sure that the network cable is connected well, and the NVR or switch supports the PoE power supply.
- Q: Where are the recorded videos saved?
- Scene 1 Recorded videos are saved in NVR.
- Scene 2 When the low cloud is enabled, recorded videos are saved in the low cloud.
- Q: The IR effect is not good? The infrared light is reflected the lens, so the effect is not good. Adjust the lens angle to avoid occlusions around the lens.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>