BEKA BA307E E Indicator Scale Card Kit Instruction Manual
- June 6, 2024
- BEKA
Table of Contents
Instructions for
E Indicator Scale Card Kit
Issue 4
2nd October 2012
BEKA associates Ltd. Old Charlton Rd, Hitchin, Hertfordshire,
SG5 2DA, UK Tel: +44(0)1462 438301 Fax: +44(0)1462 453971
e-mail: sales@beka.co.uk web:
www.beka.co.uk
This Scale Card Kit contains 30 self-adhesive scale cards (labels) printed with 28 common units of measurement, 2 blank scale cards for customers to mark on their own units of measurements, and 2 flexible strips (one for use with the small indicators, the other for use with the larger indicators).
Instructions for use
- Select the flexible strip required: The BA307E, BA327E, BA507E, and BA527E use the smaller flexible strip with a simple form at its end. The BA308E, BA328E, BA508E, and BA528E use the larger flexible strip with the complicated form at its end (see figure 1).
- Select the scale card carrying the unit of measurement required or, if the unit of measurement required is not pre-printed, mark the unit of measurement required on one of the blank scale cards.
- Position the selected self-adhesive scale card carefully on the correct flexible strip as shown in Figure 1. Fig 1 Fitting scale card to the flexible strip
- Unclip the flexible strip presently in the instrument by gently pushing it upwards and pulling it out of the enclosure. See figure 2.
- Fit the new scale card prepared in steps 1 to 3, as shown in figure 2, pushing the flexible strip fully home before pressing the tail of the strip down into the “locked” position.
Fig 2 Flexible strip carrying scale card being inserted into the slot at the
rear of the instrument.
Note: Do not fit a new scale card on top of an existing card, always
remove the existing card first.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>