OxyLED A58-1 LED Closet Light Motion Activated User Manual
- June 6, 2024
- OxyLED
Table of Contents
PRODUCT OVERVIEW
- Micro USB Port
- Adjustment Button
- Switch Button
- Sensor
- Indicator Light
- Aluminium House
- Lampshade
OPERATION
-
POWER ON/OFF. For first use, long press S2 button for 3 seconds to turn on the light and at this point it is in always on modes. Long press it for 3 seconds again to turn off it.
-
SWITCH MODES.
1)Press S2 button and the sensor flashes red light for a few seconds to turn off, which means that the motion sensor mode is enabled (Turns on when detecting movement).
2)Press S2 button again and then the sensor flashes green light for a few seconds to turn off, which means the motion & light sensor mode is enabled (Only turns on when detecting movement in dark enough condition).
3)Press it once again and the sensor will not flash, which means the always on mode is enabled. -
ADJUST COLORS & LEVELS.
1)Press the S1 button in turns, and you can cycle through 3 colors: Natural White, Warm White, Bright White, no matter what modes is enabled.
2)Long press S1 button for 3 seconds, and the brightness gradually change from bright to dim. Release the button, and then press it for 3 seconds, so the brightness gradually changes from dim to bright. (Note: When adjusting the brightness, you need to press the S1 button until the brightness is adjusted to the suitable what you think, and then release the button).
INSTALLATION
2 Installation methods, simple and easy to operate.
- Thanks to the magnetic design on the light’s back, the light can be directly attach to any flat and smooth metal surface.
- With the supplied magnetic bar and tape, you can attach it anywhere without falling down.
- Peel off the protective film and paste the tape to the magnetic bar.
- Remove the film and stick the bar to the desired surface.
- Mount the light on the magnetic bar.
- Finish and easy to remove when charging.
FIXING INSTRUCTION
PRECAUTIONS
- Do not put the light in humid or high temperature places.
- The light needs to be placed horizontally for more sensitive induction.
- Please charge before use or when the light becomes dim. It takes about 3 hours to fully charge (the indicator light is red when charging, and turns to green when fully charged).
- Do not install the light under strong light, so as not to affect sensitivity or cause misopera¬tion.
- The surface of object that attaches the magnetic bar should be as clean and flat as possible.
- The best distance between two lights is more than 1 meter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>