MouKey MwmU-5 UHF Wireless Microphone User Manual

monkey MwmU-5 UHF Wireless Microphone

TECHNIQUE SPECIFICATION

RECEIVER

• Carrier Frequency: 902-926MHz
• Dynamic Range: 96dB
• Distortion:﹤ 0.3%
• FrequencyResponse: 30-20KHz/+-2dB Signal / noise Ration: 96dB
• Receiving Sensitivity: -95dBm Transmission Delay:﹤ 3ms PowerSupply: DC12V500mA
• AudioOutput: 1×6.3mm, 2xXLRbalanceoutput

HANDHELD MICROPHONE AND BODY-PACK MICROPHONE

• Carrier Frequency: 902-926MHz
• Power Output: 10-30mW
• Harmonic Radiation:﹤- 50dBc
• Battery: 2×1.5VAAbattery Batterylife:﹥ 5h

BRIEF INTRODUCTION

Our company has designed and developed this excellent wireless microphone system, using a fully integrated solution, single-chip integrated microphone amplifier, DSP-based audio processor, phase-locked loop frequency synthesizer, and so on. Compared with the traditional discrete device system, the stability and reliability of all the circuit modules are further improved. Our microphone uses the traditional FM modulation technology, has superior RF performance and audio performance provides a professional-grade sound quality experience for the user.

MAIN FEATURES

• Optional UHF band(902-926MHz)
• All adopt the SMT process, the circuit board design is compact.
• The receiver and transmitter use LED screens to show the frequency.
• Dedicated to large and small stages, dance halls, conference rooms, speeches family entertainment and so on.
• Multiple noise control circuits refused to external disturbance and open the machine noise system.
• Excellent dynamic heart-shaped cartridge for better clear sound.
• Effective open use distance of 70-90 meters.

1.  Attention the using distance between the microphone Grille and mouth is less than 15 cm.
2.  Avoid pointing the Grille against the Horn.

BODY-PACK TRANSMITTER (OPTIONAL)

HANDHELD MICROPHONE USING TECHNIQUE

1.  Don’t hold the microphone Grille:
2.  Avoid holding the microphone in antenna position:
3.  Don’t put the two microphones to use together:

PARTS(RECEIVER)

1. POWER
2. VOL.A
3. Channel A-AF indicator
4. Channel A-RF indicator
5. DISPLAY WINDOW
6. Channel B-AF indicator
7. Channel B-RF indicator 8、VOL.B
8. ANT-A
9. ANT-B
10. MIX.OUT
11. BALANCE B
12. BALANCE A
13. DC INPUT

RECEIVER OPERATION

Connect the power:
Connect the power cable to the DC socket (10) or (1 4) of the Receiver, make sure the adaptor is suitable before using the Receiver.

Connect the audio cable:
Mix output: connect the audio cable (attached) to the MIX.OUT socket (8) (11) while the other side connect to MIX. IN or AUX IN.

Turn on the power button
The receiver is in working status.
Note: Before turn on the Receiver, turn the volume control knob (2.8) to the minimum volume, adjust the volume as needed when the Receiver is working.

Warnings of Receiver installation
Beyond 1 meter more away from the wall

HANDHELD MICROPHONE OPERATION

1.  Microphone capsule: use to pick up sound.
2.  LCD display: indicates the microphone’s working status.
3.  ON/OFF switch: control the handheld microphone to power on and off.
4.  Battery Sink: insert 2×1.5VAA battery, note to insert incorrect polarity.
5.  Battery cover: battery for fixed the microphone.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>