laia TPOD AIR PRO DUAL High Quality Signal Processor for Interactive Device of Internet Education User Manual
- June 6, 2024
- laia
Table of Contents
laia TPOD AIR PRO DUAL High-Quality Signal Processor for Interactive
Device of Internet Education
Product overview
A Digital signal processor is a unit based on the connection with the USB interface of network PC computer equipment, supporting the input of two-way wired suspended microphones, and the output of one group of audio to an active speaker. The electrical level of input and output audio can be adjusted. It has good echo cancellation and noise reduction performance in the application scenarios like Internet education interaction and network videoconference after simple installation and connection, namely, the high-quality audio requirement in remote education and conference can be achieved.
Introduction to Center Unit
- Indicators
- Suspended microphone 1 sends the signal for volume adjustment
- Suspended microphone 2 sends the signal for volume adjustment
- Volume adjustment of speaker
- Suspended microphone 1/Suspended microphone 2 interface
- The output interface of the speaker
- USB data interface
- DC supply interface
- Power on/off
Packing list
Installation
Note:
- Connect only “ + ” and signal ground “ ▼ ” for single-ended signal, no need to connect “ – ” .
- Connect “ + ” “ ▼ ” and “ – ” for differential signal.
- The distance between two suspended microphones shall be more than 2m.
- Turn on Power switch after it is well-wired according to Connection Diagram.
Operation instruction
- Open the product package, take all the devices and accessories out to check with the packing list.
- Turn the power switch of the Center Unit “ off ”.
- Following Connection Diagram and the note, first, connect two ball-shaped microphones and the active speaker, then use the USB data cable to connect with the USB interface of a PC computer, then connect the DC power adapter cable with the adapter, and finally plug the adapter into an AC outlet.
- After it is well-wired as Connection Diagram, turn three volume knobs anticlockwise to the minimum volume; then turn the Power on, the indicator glows.
- For the interaction and exchange between two meeting venues of the near-end the far-end of the network, first put through an Internet Phone at the computer-end (for example the network phone application software like QQ and SKYPE). During the calling progress, moderately turn the volumes of the microphone and speaker up, if necessary, the speaker volume of a computer device and the sensitivity of the microphone can be moderately adjusted, as long as the voice between the near-end and the far-end meeting venues can be heard clearly. The voice exchange and interaction can be conducted between the two ends once it is well-adjusted.
Note:
The device shall be applicable to a PC computer with Windows operating system, equipped with USB 1.1 or USB 2.0 interface. The USB data cable can be used Plug and Play, without an additional USB device driver.
Precautions
- You cannot connect a network computer with microphone & speaker devices including our device.
- The USB data cable shall be directly connected with a computer, or it may cause operating issues if it is connected through a USB concentrator.
- After the device is successfully connected, for the property of sound and audio equipment on the control panel of the computer, it will show “Model of the unit” in the default unit for play (output) and record (input), or the “model of the unit” needs to be reselected for confirmation.
- Please do not try to repair the unit on your own, which may cause electric shock hazard. Be sure to request repairs from the dealer where you purchased the unit.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>