Nintendo Wii Remote and Nunchuck Controller Combo User Guide
- June 6, 2024
- Nintendo
Table of Contents
Nintendo Wii Remote and Nunchuck Controller Combo
Remote and nunchuck for Wii operation guide
- First, connect power supply of wii game console including inductor and AV cable.
- Install 2*AA dru battery in the remote for wii.
- There is a red color code key SYNC on the back of the remote, the four indicators on the front of the remote will be blinking quickly by pressing it (sufficient battery power).
- Press the code key which is on the wii game console to connect the game console with the remote by pairing (after synchronization, the No. 1 indicator will be solid bright).
- Adjust the position of the sensor bar (position of the cursor).
- You can play games by reading U-disk and DVD using the remote for Wii (Nunchuck is required to be connected with the remote when reading games).
Fcc Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>