MOXA ioLogik R1200 Series Universal Controllers and I-Os Installation Guide

: June 6, 2024
: MOXA

Table of Contents

Package Checklist
Specifications
Installation
Switch Settings
- LED Indicators
System Configuration
Documents / Resources

ioLogik R1200 Series
Quick Installation Guide
RS-485 Remote I/O
Version 4.1, January 2021
@ 2021 Moxa Inc. All rights reserved.

Package Checklist

1 ioLogik R1200 series remote I/O product
Quick installation guide (printed)

Specifications

Input Current| ioLogik R1210 Series: 154 mA @ 24 VDC
ioLogik R1212 Series: 187 mA @ 24 VDC
ioLogik R1214 Series: 207 mA @ 24 VDC
ioLogik R1240 Series: 216 mA @ 24 VDC
ioLogik R1241 Series: 343 mA @ 24 VDC
---|---
Input Voltage| 12 to 48 VDC
Operating Temperature| Standard Models: -10 to 75°C (14 to 167°F) Wide Temp. Models: -40 to 85°C (-40 to 185°F)
Storage Temperature| -40 to 85°C (-40 to 185°F)

Installation

Jumper Settings

The models with DIO or AI channels require configuring the jumpers inside the enclosure. Remove the screw located on the back panel and open the cover to configure the jumpers.

|
---|---
DIO mode configuration is shown to the right (default: DO Mode).| The Analog mode configuration is shown to the right (default: Voltage Mode).

I/O Wiring

Digital Input/Output (Sink Type)

NOTE A “load” in a circuit schematic is a component or portion of the circuit that consumes electric power. For the diagrams shown in this document, “load” refers to the devices or systems connected to the remote I/O unit.

Mounting

The ioLogik R1200 is designed with a vertical form factor, and can be used with both DIN-Rail and wall mounting applications. When mounting on a rail, release the bottom mounting kit, install the ioLogik on the rail, and then restore the bottom mounting kit to fix the ioLogik to the rail. When using wall mounting, release both the upper and bottom DIN-Rail kits.

Power and Networking

Connect the +12 to +48 VDC power line to the ioLogik R1200’s terminal block V+ terminal; connect the ground from the power supply to the V- terminal. Connect the ground pin ( ) if earth ground is available.

NOTE For safety reasons, the wires attached to the power should be at least 2 mm (12 gauge) in diameter.

Switch Settings

The R1200 series provides Dual/Rep and Run/Initial switch settings to set up the communication mode.

Duel (Default)	Dual RS-485 mode
Rep	Repeater mode
Run	User define communication parameters
Initial (Default)	Initial RS-485 communication parameters

LED Indicators

Type	LED Color	LED Action
PWR	Green	On:
Off:	Power Off
RUDY	Green/ Red	Green:

System Configuration

ioSearch Utility

ioSearch is a search utility that helps users locate an ioLogik R1200 on the local network. The utility can be downloaded from Moxa’s website.

Load Factory Default Settings

There are three ways to restore the ioLogik R1200 to the factory default settings.

Hold the RESET button for 5 seconds.
Right-click the specified ioLogik in the ioSearch utility and select “Reset to Default.”
Select “Load Factory Default” from the web console.