HANDY 10368 Electric Drill Grinder Polsiher Set User Manual
- June 6, 2024
- Handy
Table of Contents
10368
ELECTRIC DRILL
GRINDER POLSIHER SET
10368 – Electric drill, grinder, polisher set
The HANDY DRILL sanding, engraving, and drilling machine has been specially
developed for home, manicure/pedicure, and DIY purposes. You can use it to
drill small holes, polish, engrave, or even cut. It can be ideal for removing
burred edges. Maximum shaft diameter Ø3.2 mm. The various chucks can be
connected easily and quickly. Thanks to its compact size and weight, the tool
is easy to handle, even in hard-to-reach places. It can also be suitable for
precise machining of wood, metal, and plastic.
Use
Hold the device as if you were holding a writing instrument. Be careful not to
press the chuck lock button (B) during operation, as this may damage the
device.
The switch (C) on the end of the appliance can be used to switch the appliance
on and off. Before connecting to the mains, make sure that the power button is
in the “0” position. To avoid dangerous situations, only connect the device
to a power source when it is set this way!
Accessories
A – Chuck cap
B – Chuck lock button
C – On / Off switch
D – Clamping head (chuck)
E – Clamping heads
Change of accessories
- Turn off the device and make sure it is completely stopped. (For higher security and to avoid injuries remove the power cable from the wall socket!)
- Push and hold the collet lock (B) button and turn the collet until the button descends!
- When the collet has locked, turn the collet closing cap (A) and remove the accessory/head.
- Place the new accessory or head onto the collet and screw the closing cap to close, while the LOCK BUTTON is held all time.
- Release the LOCK BUTTON!
ATTENTION!
- Always make sure that the charging cable and the device are intact before use.
- Do not use it in humid environments, rain!
- Never use near flammable gases or liquids.
- Do not force the machine if you feel it slow down or stop, turn it off, or finish the operation
- Never press the chuck lock button during operation!
- Wear protective clothing ( goggles, mask, gloves) during use.
- Do not touch the drill/grinder tip during operation, as this may cause injury!
- It is strictly forbidden to disassemble or modify the device! In the event of a malfunction, contact a specialist for repairs.
Technical data
Adapter input voltage:
Adapter output voltage:
Operating voltage:
Performance:
Power consumption:
Idle speed:
Chuck capacity:
Max tool diameter (disc):
Dimensions:
Vibration:
Noise pressure:
Contact protection class:
Protection: Cable length:
Color:
Weight:
Material:| 100 to 240 V, to 50 /60 Hz
12 V DC, 500 mA
12 V DC
max. 6 W
max. 500 mA
16,000 rpm
1 – 3.2 mm
35 mm
125 x Ø37 mm
2.58 m / s
70 dB
III
IP20
1 + 1 m
Orange / Black
~ 150 g
Plastic
---|---
Product Code: 10369
max. Ø35mm • DC 7.4 V Li-ion Battery 1100 mAh • max. R.P.M. 25000/min
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>