NuPhy Air75 Mechanical Keyboard User Manual

June 14, 2024
NuPhy

Air75 V2
KEYBOARD
QUICK GUIDE

& POSTER

System Selection

win mode
Mac mode

Connection Mode Selection

Power Off
Wired mode
Wireless mode

  • In the wired mode, it is necessary to use a data cable to connect with the device.

Wireless Device Connection

Short press to switch between devices; long press 3 seconds to enter pairing mode. Plug the 2.4G receiver into your computer after pressing FN + 4.

NuPhy Air75 Mechanical Keyboard - overview 2

Backlight Settings

FN + ∧/∨ Brightness + –
FN+ < Backlight effect switching
FN+ > Backlight color switching
FN+ </> Backlight speed

Sidelight Settings

FN + M + ∧/∨ Sidelights Brightness + –
FN+M+ < Sidelight effect switching
FN+M+ > Sidelight color switching
FN + M+ </> Sidelight speed

Sleep Mode Setting

FN+] Turn the Sleep mode on or off

  • If there is no operation on the keyboard, it will turn off the light and enter sleep mode after 6 minutes.

The screenshot shortcut

Section Screenshot
Full screen screenshot
Full screen screenshot

Other Key Combos

FN+\ Enable/disable permanent battery display

Factory Reset

FN+[ Long press for 3 seconds to restore factory settings

VIA keymap configurator

VIA is open source software developed independently from NuPhy and released under open VATE source licenses. To obtain the latest VIA releases please visit nuphy.com/pages/console or VIA’s official website caniusevia.com. If for any reason your keyboard cannot be detected by VIA under re the wired mode, feel free to contact our technical support.

Mac Mode: LAYER 0/1
Win Mode: LAYER 2/3

Air75 V2

IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. This device may not cause interference, and
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals