Handstandspromo SNOGLOBE LED Light Transparent Wireless Speaker Instructions
- June 6, 2024
- Handstandspromo
Table of Contents
**Handstandspromo SNOGLOBE LED Light Transparent Wireless Speaker Instructions
**
How to Charge
- Connect USB end of charger (included) to a computer or wall charger
- Connect Micro USB end of cable (included) into the Micro USB port on device
How to Connect
- Turn on SnoGlobe Speaker
- Open Bluetooth setting/pairing setting on chosen device (phone or computer) and select SnoGlobe
Control Panel
A. TF Slot
B. USB Input
C. Aux Input
D. Micro USB port
E. < long press Volume down; short press skip back
F. On/Off Switch; short press pause
G.> long press Volume up; short press skip forward
Specifications
- Speaker Power: 5W
- Battery Type: Lithium polymer 400 mAh
- Input: 5V = 2A (Max)
- Wireless Output = 5V =1A
- USB Output: 5V = 2A
- TF Card Capability
Include on exterior of box
FCC Logo, CE logo, recycle logo and the no trash can logo above our company information, Model #: XV-BS1955 FCC ID: 2AMZYSNOGLOBE HandStands website, Made in China and country of origin
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in an installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>