FURITEK 30A-50A Stinger Brushless Power System Instruction Manual

Table of Contents

Specifications

Support sensorless brushless DC and brushed DC motor (config via the app, default is brushless)
FOC (Field-oriented control) technology
Plug & Play designed for AXIAL SCX24 crawlers
5V/ 6.5V 2.5A Built-in BEC (config via app)
Support 2S-3S lipo battery – Mini size and lightweight
Super easy programming via App on both Android and IOS
Firmware update available (Bluetooth module required)
Real-time telemetry up to 10Hz – Ability to run with stock TX/RX or any other TX/RX

Pinout

Connect Brushed/Brushless motor to ESC

The DEFAULT configuration is a Brushless motor, if you use a BRUSHED motor, please configure it below

Step 1 : Please make sure to plug your battery into ESC and open the FURICAR app on Android or IOS device
Step 2 : Please Click the Setting icon (see picture)
Step 3 : Please click the”Motor Type” menu, a new window pops up, select “Brushless” or “Brushed” and then click “OK”

Esc Manual calibration

A.Calibration on ESC Mainboard:

Step 1: Turn on your radio and move your radio throttle stick FORWARD or throttle stick BACKWARD
Step 2 : Plug the battery into your ESC (The ESC LED indicator will start blinking followed by a motor beeping sound) and then the ESC LED indicator will blink 4 times and the motor will beep 4 times)
Step 3: Set to 0% Throttle or lowest speed (please make sure that your radio throttle sticks at NEUTRAL POSITION, ESC LED indicator will blink 1 time and motor will beep 1 time)
Step 4: Set to 100% Throttle or Maximum speed (move your radio throttle stick FORWARD and the ESC LED indicator will blink 2 times and the motor will beep 2 times)
Step 5: Setting up of your BRAKE (move the radio throttle stick BACKWARD and the ESC LED indicator will blink 3 times and the motor will beep 3 times)
Step 6: When the LED light on your ESC blinks 4 times and the motor beeps 4 times, you have successfully calibrated your Furitek esc

B . Calibration via App: (Your esc needs Bluetooth to communicate with the app)

Step 1: Please make sure to plug your battery into ESC and open the FURICAR app on an android or IOS device
– Step 2: Please click “MENU” and click “THROTTLE”

Follow the intructions on the app screen till the calibration

Change password

Step 1 : Please make sure to plug your battery into ESC and open the FURICAR app on an android or IOS device.
Step 2: Please Click the Setting icon (see picture)
Step 3 : Please Click the”Change Password” menu, a new window pops up, type your new password and then click “OK”

Change Output voltage

( Warning: High Voltage might kill your servo, make sure your servo can work with high voltage)

Step 1: Please make sure to plug your battery into ESC and open the FURICAR app on Android or IOS device
Step 2 : Please click “Menu” and click “Running”
Step 3 : Please click ”Output voltage” and then select “5V or 6.5V”
Note: Output voltage “6.5V” led on main Esc always on when active Output voltage “5V” led on main Esc off when active

Q: How do I switch between Brushless and Brushed motor configurations?
- A: Use the FURICAR app to select the Motor Type menu and choose between Brushless or Brushed configurations.
Q: What is the default password for Bluetooth connection?
- A: The default password to connect to Bluetooth is 1234.