ION Total PA Prime High-Power Bluetooth Speaker System User Guide
- June 6, 2024
- ION
Table of Contents
ION Total PA Prime High-Power Bluetooth Speaker System
Box Contents
- Total PA Prime
- XLR Linking Cable
- Power Cable (5 ft./ 150 cm)
- Speaker Stand
- Microphone with cable (15 ft. / 450 cm
- Quickstart Guide
Features
- Display: This screen shows information relevant to Total PA Prime’s current operation. See the full User Guide to learn more.
- Control Knob: Tum this knob to adjust the main volume (overall output) of the loudspeaker. Push this knob 10 select and make adjustments to the mic 1 volume, the mic 2 volume, source volume, echo effect, high EQ, and low EO.
- Ned: Press this button to tune in to a radio station or go to the next track on a Bluetooth-connected device, SO card, or USS drive. Press and hold in radio mode to seek.
- Play/Pause: Play/pause the use, SD, or Bluetooth source. In USB/SD mode, press and hold this button to stop playback and return to the beginning of the list of files. In Radio Mode, press this button to select a previously saved preset station. To save the current station as a preset, press and hold this button, use the Tune/Track buttons to select which preset you want to save it to, and press this button again to confirm.
- Previous: Press this button to tune in to a radio station or go to the previous track on a Bluetooth-connected device, SD card, or USB drive. Press and hold in radio mode to
- RepeaVLink: In USS or SO mode, press this button 10 to repeat a single track, folder, or all tracks. Press and hold this button to start stereo linking to another compatible ION speak&r (see ionaudio.com !or a list of compatible speakers). Then. repeat this process on the other speaker. See the full User Guide to learn more.
- Mode: Press this button to select the audio source to use: use, SO, FM radio, Aux, or Bluetooth
- Lights: Press this button to toggle between three modes for the lights on the front panel.
- use Port: Connect a USB flash drive here to play supported audio files.
- so Card slot: Insert an SO card here to play supported audio files.
- Acoustic Optimization-: Use these presets to select the Venue/Event and the speaker will automatically jump to an appropriate volume level mill, EQ setting, light mode, and mic echo setti ng. For best results, set your music source at 100% volume. See the full User Guide !or a chart of the specific settings.
- Mic Inputs 1/4 I XLR): Connect a microphone or mic-level source to these inputs.
- Au11 Inputs (1/8 stereo / XLR line-level: These inputs can be used to connect a CO play8f, MP3 player, or another audio source.
- Mix Output (XLR): Connect this output to a speaker, mi11er, or recorder
Important satety instruetons
-
Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions.
-
Do not use is apparatus near water
-
Do not block any ventilation openings applicable. Install in accordance with the manufacturer’s instructions. Do not install this equipment in a confined or “boxed-in” space such as a bookcase or similar unit, and maintain good ventilation conditions. The ventilation should not be impeded by covering the ventilation openings with hems such as newspaper, tablecloths, curtains, etc.
-
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers that produce heat. Do not place exposed flame sources such as lighted candles on the apparatus
-
Do not delete the safety purpose of the polarized or grounding-type plug if applicable. A polarized plug has two blades one wider than the other. A grounding type png has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. f the provided tag does not t into your outlet, consult an electrician for replacement of the obsolete outlet.
-
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
-
Only use attachment/’accessories specified by the manufacturer.
-
Use only the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus (f applicable. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over. Urglug his apparatus during hiring storms or when unused for long periods of time -
Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way. such as a power-supply cord or plug s damaged, liquid has been spilled or objects have been taken into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
-
IntemaliExtemal Voltage Selectors (f applicable internal or external voltage selector switches, f any. should only be reset and re-equipped with a proper plug for ahemative voltage by a qualified service technician. Do not attempt to alter this yourself
-
Power Sources f applicable: This product should be corrected to a power supply only of the type described in these operating instructors or a marked on the unit.
-
Caution Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type. The batteries battery pack or an installed battery) shall not be exposed to excessive heat such as sunshine, fire, etc.
-
0f applicable) Where thee mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain ready operable
-
Warming of applicable: Provide an earthing connection before the mains plug is connected to the mains. When disconnecting the earthing connection, be sure 1o disconnect it after pulling the mains plug out Tremaine.
-
For Class l apparatus only f applicable): This symbol means the equipment is a Class l or double-insulated electrical appliance. t has been degree such a way that does not require a safety connection to electrical earth.
-
Class Ii Wiring (if applicable To reduce the risk of electric shock, the external wiring connected to the terminals with “Class ll Wiring” requires Class ll wiring installed by an instructed person or the use of ready-made leads or cord
-
This apparatus is for professional use only, the intended operational climate: is moderate.
-
0f applicable) When moving or not using the appliance, secure the power cord wrapt with a cable te, Be careful not to damage the power cord. Before using it again, make sure the power cord has not been damaged. F the power cord has been damaged at all, bring the unit to a qualified service technician for repair or replacement as specified by the manufacturer
-
Warming if applicable: ExDessve sound pressure nigh volumes) from headphones can cause hearing loss
-
Warming (f applicable Please refer to any important information (eg. electrical, safety, etc) printed on the exterior bottom enclosure or the rear one before Petaling or operating the product.
-
Warming (f applicable: Terminals marked with the lightning bolt symbol may be of surfers magnitude to constitute a risk of electric shock
-
Minimum distances of 10 mm around the apparatus for sufficient ventilation
-
Clip LED: The Clip LED will flash red if the signal from the input }Seka or media panel audio source is clipping. II this happens. decrease the main volume using the Control Knob or the source, or the mic volume (II a loud device is ph. Jggecl into either).
-
Power Switch (not shown): Flip this switch to toggle the speaker’s pow&r on or off.
Safety Notices
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE ANY COVER. NO
USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
ONLY.
DANGEROUS VOLTAGE: The lightning flash with the arrowhead symbol within the
equilateral triangle is intended to alert the user to the presence of
uninsulated “dangerous voltage” within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electric shock.
INSTRUCTIONS: The exclamation point within the equilateral triangle is
intended to alert the user to the presence of important operating and SA TB8
maintenance (servicing) instructions in the literature accompanying this
appliance.
WARNING: To reduce the risk of fire or electrical shock, do not expose this
appliance to rain or moisture. Electrical equipment should NEVER be kept or
stored in damp environments.
NOTICE CONCERNING FCC REGULATIONS: You are cautioned that changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: (a) reorient or relocate the receiving antenna; (b) move
this unit; ()increase the separation between the equipment and receiver, (d)
connect the equipment into an outlet on a circuit different from that to which
the receiver is
connected; (e) be sure that all cables are properly shielded, using a choke or
ferrite where appropriate; ) consult the dealer or an experienced
radio/television
technician for help.
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Radiation Exposure
Statement: This equipment complies with radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20 cm between the radiator and your body.
f apparatus contains a coin/button-cell battery:
Warning: Do not ingest the battery-chemical burn hazard. The remote
control supplied with this product contains a coin/button-cell battery. if the
coin/button cell battery is swallowed, it can cause severe internal burns in
just 2 hours and can lead to death. Keep new and used batteries away from
children.
If the battery compartment does not close securely, stop using the product and
keep it away from children. if you think batteries might have been swallowed
or placed inside any part of the body, seek immediate medical attention.
Disposal of Batteries (if applicable): Never dispose of any types of
batteries in fire or near excessive heat or direct sunlight. Overheated
batteries can rupture or explode. If you are unsure of how or where to dispose
of a battery, refer to your local ordinances for the proper location, method,
etc. Alkaline batteries & lithium button cell batteries: You can safely
dispose of alkaline and lithium button cell batteries with normal household
waste. They do not pose a health or environmental risk during normal use or
disposal. (Alkaline batteries are composed primarily of common metals like
steel, Zinc, and manganese.) Do not dispose of large amounts of alkaline or
lithium button cell batteries in a group. Used batteries are often not
completely “dead.” Grouping them together can bring these “live” batteries
into contact with one another, creating safety risks. To avoid this, insulate
each battery with tape or other non- conductive material to ensure it does not
discharge. Proven cost-effective and environmentally safe recycling processes
are not yet universally available for alkaline and lithium button cell
batteries. Some communities offer recycling or collection of these batteries.
For more information, refer to your local ordinances or conta your local
government. Lead-acid batteries: Dispose of lead-acid batteries by bringing
them to an electronic waste center or recycling center, or dispose of them in
accordance with your local ordinances. (Rechargeable lead-acid batteries are
the same type used in automobiles and should be disposed of in a similar
fashion.) This device contains license-exempt transmitter(s/receiver(s) that
comply with Innovation, Science and Economic Development ((SED) Canada’s
license-exempt RSS(s). Operation is subject to the following two conditions:
- this device may not cause interference
- this device must accept any interference, including interference that may cause undesired operation of the device.
Service Instructions
Disconnect power cord before servicing. Replace critical components only with factory parts or recommended equivalents. For AC line powered units: Before returning repaired unit to user, use an ohmmeter to measure from both AC plug blades to all exposed metal parts. The resistance should be more than 2,000,000 ohms.
Trademarks and Licenses
ON Audio is a trademark of inMusic Brands, Inc., registered in the U.S. and other countries. App Store is a trademark of Apple Inc., registered in the U.S. and other countries. Android and Google Play are registered trademarks of Google Inc. The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by ION Audio is under license. All other product names, company names, trademarks, or trade names are those of their respective owners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>