S5-800W JOYOR Electric Scooter User Manual

S5-800W JOYOR Electric Scooter

Product Information

The JOYOR Electric Scooter is a personal electric scooter designed for adults. It is limited to one person and should not be used to carry others. Minors should use it under adult supervision.
Please read this instruction manual carefully as it contains important safety information. Keep this manual properly for future reference.

Safety Instructions for Use

• This product is an electric scooter for adults and should not be used by minors.
• Always wear safety helmets and other protective equipment when riding.
• Do not ride in unsafe or illegal places such as motorways.
• Practice riding in open spaces first and drive after skillfully controlling the scooter.
• Do not perform dangerous actions or ride with one hand while the scooter is driving. Keep your feet on the pedal.
• Do not turn off the power supply while the scooter is driving.
• Avoid passing through steps with a gap of over cm, as it may cause the scooter to overturn and injure the driver or damage the scooter. Steps below cm should also be avoided as much as possible.
• In case of rough or uneven road conditions, slow down or get off the scooter to push.
• Adjust the height of the product to the appropriate position to ensure driving safety.
• Do not ride on slippery roads with oil or ice on the surface.
• Do not use this product in an environment below -°C.
• Avoid immersing the product in water more than cm deep and put it on hold to avoid damage to the electrical parts.
• Please do not leave it in a severely humid place for a long time.
• Plastic bags are in danger of suffocating babies.

List of Main Components and Parameters of Products

Main Components

Parameter Table

Product Usage Instructions

Operation instruction

Fold and Expand

To fold the electric scooter, follow these steps:

1. Make sure the scooter is turned off and the power supply is disconnected.
2. Hold the handlebars firmly and press the folding mechanism button located near the base of the handlebars.
3. Gently push the handlebars forward until they are parallel to the footboard.
4. Secure the folded scooter using any provided locking mechanisms or straps.

To expand the electric scooter, follow these steps:

1. Make sure the scooter is turned off and the power supply is disconnected.
2. Release any locking mechanisms or straps securing the folded scooter.
3. Gently pull the handlebars towards you until they are fully extended and locked in place.

Riding Operation

To ride the electric scooter, follow these steps:

1. press for 3S to enter the setting interface or return to the main interface. Short press to switch setting options. After setting,long press to return to the main interface.

2. Power on password function:After entering the setting interface,press to switch to Pl: press or to adjust the value, press@to switch the position, and enter 11S9 to enter the system setting.Then press to switch to P2: press or to select On or Off. The default password of the instrument is 1111. press to switch to P3 to change the password.
   Note: The system starts up without password by default; If you forget the password, press and  for 2s to reset the default password.

3. Set zero start:After entering the setting interface, enter 11S9 in Pl interface to enter system setting,then press to switch to PB: press or to select On or Off.
   Note:The system defaults to non-zero startup. After startup, it defaults to gear 1. In order to ride safely, please confirm to start in gear 1. Then press down the acceleration handle while sliding with your feet to start riding.

4. Enable cruise: After entering the setting interface, enter 1159 in P1 interface to enter system setting, then press to switch to P9: press or to select On or Off. After starting cruise, press the acceleration handle until the cruise icon lights up,At this time, releasing the handle will not stop the assistance; When shifting gears, braking or pressing the acceleration handle again,you will exit cruise.

5. If you encounter someone or obstacles in front of you during riding, please release the throttle first, and brake the left brake handle (rear brake) first and then brake the right brake handle (front brake) next to stop braking or deceleration.

How to Charge

To charge the electric scooter, follow these steps:

1. Make sure the scooter is turned off.
2. Connect the charger to a power outlet.
3. Connect the charger plug to the charging port on the scooter.
4. The charging indicator should light up, indicating the charging process has started.
5. Allow the scooter to charge until the battery is fully charged.
6. Disconnect the charger from the power outlet and the scooter.

Product Maintenance

To ensure the optimal performance and longevity of the electric scooter, follow these maintenance guidelines:

• Tire: This product tire uses rubber elastic tire. When the tire present obvious wear or rupture and needs to be replaced in time, please contact the dealer to replace the original tire. Every month, please check a scooter to see if there are any loose screws. If there are loose screws, please tighten them in time.
• Brake: This product adopts the braking mode of front disc brake and rear drum brake. Usually, more attention should be paid lo check the thickness of brake friction plates. ff there is serious wear, it should be replaced in time to prevent adverse consequences caused by braking.
• Battery: when you get the electric scooter for the first time, please charge the battery and use it.
• If the vehicle is not used for a long time, it must be charged at least once a month.
• If the state power cannot be charged, please contact the after-sales service as soon as possible.
• The battery damaged due to other abnormal factors such as water inflow and collision is not covered by the warranty.
• If the intensity and frequency of use of the scooter is high, you need to check the screws of the scooter once a month and replace the screws every half a year to avoid bad conditions.
• The lithium battery equipped by our company has a charging cycle of at least 500 times, which can generally reach more than 600 times in normal use.
• Wben the battery is fully charged and the mileage is only half of the factory mileage, it is recommended lo replace the lithium battery.

After-sales maintenance

Please contact your local dealer for after-sales maintenance.
During the warranty period, if the following reasons cause faults and damages, they are not within the warranty scope:

1. Not properly maintained and repaired in accordance with this manual.
2. The electric scooter is used for other purposes to perform dangerous actions such as special effects, resulting in damage or functional failure.
3. Any self-disassembly or use of parts outside the original factory.
4. Using tl1e scooter body and scooter body accessories damaged by mistake, traffic accident or accidental collision.
5. Incomplete labeling, water inflow and mismatched parts numbers.
6. Driving on abnormal roads to use damage or functional failure.
7. Business rental use or improper non-franchise use.
8. Causes of force majeure.
9. Exposing this product to the sun for a long time or rain for a long Lime. thus causing the rapid aging and functional failure of this product.

For any further assistance or inquiries, please refer to the complete user manual or contact our customer support.
Whatsapp: +86 134 8692 8696
After sale email: joyoraftersales@gmail.com
If you have any questions please contact our after-sales department, we will give you an answer within 24 hours (except holidays)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>