CARLO GAVAZZI UWPMM1UL2X UWPM Master Concentrator Gateway Instruction Manual
- June 5, 2024
- CARLO GAVAZZI
Table of Contents
Name:UWPMM1UL2X
FCC ID:SNJWLM
IC: 7118D-WLM
UWPM
Master concentrator gateway
Instruction manual
UWPM is a master concentrator gateway that permits UWP 3.0 to gather data from
multiple UWPA. This allows for the setting up and operating of a secure and
robust wireless data network in the ISM band.
|
---|---
COMPONENTS
Element | Description |
---|---|
A | UWPM |
B | Antenna (2 m cable) |
FEATURES
General features
Material | Noryl |
---|---|
Protection degree | Terminals: IP20 |
Front: IP50
Mounting| On DIN rail
Dimensions| See picture 1
Environmental specifications|
Operating temperature| From -25 to +55 °C
Storage temperature| From -30 to +70 °C
Power supply|
Power supply| From 115 to 240 V ac 24 V dc
Consumption| DC: 1.3 W max.
AC: 5.5 VA max.
Connector| Screw terminals
LED
Colour| Description
Green| Power supply
Yellow| HSBus
Blue| LoRa® RF technology
communication
HSBus port
Bus type| RS485 high-speed bus
Protocol| Internal proprietary protocol
Number of slaves| Max 3 per UWP 3.0
Connection type| By local bus (left and right connectors) or terminals GND,
A(-), B(+) T1, T2: terminal ratio inputs
Wireless communication
Protocol| LoRa® (private UWP network in combination with UWPA)
Frequency| EU 868 MHz ISM band
Encryption| Embedded end-to-end AES128 encryption
Antenna| Included high-performance antenna (SMA connector, cable length 2m)
Diagnostics| Signal strength UWPA status
UWPA number| Maximum: 50 UWPA per UWPM. The number may change according to the
transmission interval and the interferences
Note: to guarantee reliable communication, install a maximum of three UWP3.0 systems with UWPM gateways close to each other.
General warnings
The installation of the device is strictly reserved for persons who know
how to useit safely.
This manual is an integral part of the product. It should be consulted for all
situations tied to installation and use. It must be kept in good condition and
in a clean location accessible to all operators.
NOTICE: no one is authorized to open the device. This operation is reserved exclusively for CARLO GAVAZZI technical service personnel.
Compatibility
UWPM is compatible UWP 3.0 and UWPA.
MAINTENANCE AND DISPOSAL
Cleaning
Clean UWPM with a soft cloth. Do not use abrasives or solvents.
Responsibility for disposal
The product must be disposed of at the relative recycling centers specified by
the government or local public authorities. Correct disposal and recycling
will contribute to the prevention of potentially harmful consequences to the
environment and persons
Configure UWP 3.0 and UWPM to gather data from UWPA
-
Configure UWPA devices and export the .zip file for integration into UWP 3.0.
-
Connect UWPM to UWP 3.0 (see the relevant procedure).
-
Add UWPM into the configuration by using the Tool.
Note: by adding more UWPM devices, it is possible to connect more UWPA devices. -
From UWP 3.0 Tool, import the .zip file.
-
Select the desired devices and variables.
-
Send the configuration to UWP 3.0.
Connect UWPM to UWP 3.0
- Turn the UWP 3.0 off (picture 2).
- Connect the two devices (see picture 3).
- Connect the antenna and fix it by using the included support.
- Connect the power cables.
- Turn on (picture 4).
Colour | LED status | Description |
---|
Green
| ON| Power supply OK
OFF| No Power supply
Fast blinking| Hardware failure
Yellow
| ON| HS Bus communication in progress without errors
OFF| ****
HS Bus communication error
Fast blinking
Blue
| Single blink| The received message is valid
Fast blinking| The received message is not valid or has been sent by a UWPA
not included in the configuration
Slow blinking| Confirmation of message reception (acknowledge transmission) or
reply to the joint request.
UCS desktop (Windows 7 or later)
www.productselection.net/Download/UK/ucs.zip
RED declaration of conformity
www.productselection.net/MANUALS/UK/RED_declaration.pdf
2011/65/EU (RED)
2014/30/EU (EMC – Electro Magnetic Compatibility)
Immunity: EN61000-6-2
Emissions: EN61000-6-3
FCC COMPLIANCE STATEMENT:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
This radio transmitter has been approved by the FCC to operate with the
antenna types listed below with the maximum permissible gain indicated.
Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for
use with this device.
Interface and frequency range | Type | Max Gain |
---|---|---|
LoLRoaR(a90(39.002-.391-29.61M1.H9z)MHz) | Dipole Antenna | +2.15 dB |
This device complies with the FCC RF exposure limits and has been evaluated in
compliance with mobile exposure conditions.
The equipment must be installed and operated at a minimum distance of 20 cm
from the human body.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. We,
Carlo Gavazzi controls Spa
Via Safforze 8, Belluno
IT-32100 ITALY
www.gavazziautomation.com
hereby declare that the equipment bearing the model name specified below was
tested conforming to the applicable FCC Rules and Regulations Title 47 Part 15
under the most accurate measurement standards possible and that all the
necessary steps have been taken and are in force to assure that the production
units of the same equipment will continue to comply with the Commission’s
requirements.
Unique Identifier:
Type of product: Wireless endpoint gateway
Brand name: Carlo Gavazzi
Model name: UWPAM1US1L2X
FCC ID: SNJWLA
IC: 7118D-WLA
Name: UWPMM1UL2X
FCC ID: SNJWLM
IC: 7118D-WLM
Responsible Party – U.S. Contact Information Company:
Carlo Gavazzi Inc.
750 Hastings Lane,
Buffalo Grove, IL 60089, USA
Tel: +1 847 465 6100
Fax: +1 847 465 7373
sales@carlogavazzi.com
2020-11-02 | 8021879 | COPYRIGHT ©2020
CONFORMITY
ISED COMPLIANCE STATEMENTS
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with ISED license-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
This radio transmitter has been approved by the ISED to operate with the
antenna types listed below with the maximum permissible gain indicated.
Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with
this device.
Interface et bandes des fréquences | Type | Max Gain |
---|---|---|
L LLooRRaa((990032..03–991121.6.9MMHzH) z) | Dipole Antenna | +2.15 dB |
This device complies with ISED RF exposure limits and has been evaluated in
compliance with mobile exposure conditions.
The equipment must be installed and operated at a minimum distance of 20 cm
from the human body.
This Class B digital apparatus complies with Canadian ICES-003.
IFT COMPLIANCE STATEMENTS
2020-11-02 | 8021879 | COPYRIGHT ©2020
http://www.productselection.net/
CARLO GAVAZZI Controls SpA
via Safforze, 8 32100 Belluno (BL) Italy
www.gavazziautomation.com
info@gavazzi-automation.com
info: +39 0437 355811 / fax: +39 0437 355880 2019-08-29 | 8021966 |
COPYRIGHT ©2019
Documents / Resources
|
CARLO GAVAZZI UWPMM1UL2X UWPM Master Concentrator
Gateway
[pdf] Instruction Manual
WLM, SNJWLM, UWPMM1UL2X UWPM Master Concentrator Gateway, UWPMM1UL2X, UWPM,
Master Concentrator Gateway
---|---
References
- Automation.com - News & Resources for Industrial Automation
- Industry-leading products - GavazziAutomation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>