iHome AX-38 True Wireless Earbuds User Guide
- June 5, 2024
- iHome
Table of Contents
AX-38 True Wireless Earbuds
User Guide
Package Contents:
- AX-38 True Wireless Earbuds
- Charging Travel Case
- 8 Ear Cushions in 3 sizes (2 Small, 2 Large, 4 Medium)
- USB Charging Cable
- Instruction Manual
- Lanyard
Specifications:
Bluetooth® Version: 5.0
Working distance: 33 ft
Charge Connector: Micro USB
Speaker Size: <D6 mm
Frequency Response: 20Hz – 20kHz
Sensitivity: 105 dB土3 dB
Charging voltage: SV/500 mA
Case Battery: 400 mAh
Case Charge time: 2 hrs
Earbuds Battery: 2 x 50 mAh
Earbuds Charge time: 1.5 hr
Distortion Rate: <5% at kHz
Operation Guide
Getting Started
Before using this device, fully charge it.
Charging instructions can be found on page 6.
Open the charging case and take out the earbuds. Both LED lights will flash
red and blue until one of the earbuds flashes red and blue, while the other
earbud flashes blue, indicating that the right and left earbuds have synced
to each other.
Pairing
-
Go to Bluetooth® Settings on your mobile device.
-
Turn Bluetooth ON, on your device.
-
On your Bluetooth® device, select
“iHome AX-38” from the list of available devices. -
The earbud indicator LED will flash blue to indicate they are connected.
Basic Functions
On either earbud, hold the control button for 3 seconds to power on or off.
Right Earbud:
Double press the control button to play or pause the audio.
- Press and hold to skip to the next audio track.
- Single press to raise the volume.
Left Earbud:
- Press and hold to skip to the previous audio track.
- Single press to lower the volume.
Phone calls
When there is an incoming call, the unit will pause the playback and ring to
alert you of the call. Phone call functions work the same on either of the
earbuds.
To answer an incoming call, single press the control button of either earbud.
To end a call, double press the control button. To reject an incoming call,
press and hold the control button.
Volume controls may not work during phone calls with some smartphone models.
Troubleshooting
Earbuds do not sync with each other:
- Place the earbuds in the case, then take out the earbuds, ensuring both earbuds are turned on.
- On each earbud, press and hold the control surface for 5 seconds. The earbud will turn off after the LED flashes red 3 times.
- Replace the earbuds in the charging case.
- Repeat the Getting Started process.
Earbuds do not pair to the device:
- Turn the Earbuds OFF by pressing the control surface on each earbud until the LED blinks red, and then turns off.
- Replace the earbuds in the case. Turn your device’s Bluetooth® OFF and then back ON. Then repeat the pairing process.
Charging
-
Replace the earbuds in the case.
-
Connect the Micro USB charging cable to the charging port on the front of the case.
-
Plug the cable into a standard USB SV/500 mA or higher power output.
When you plug the case into a charging mechanism the light to the left of the case charge port turns red. This means the case battery is being charged.
While this is happening the lights on the buds inside the case will be off.
The red light on the front of the case will blink when fully charged and go out if the case is unplugged from the power source. -
When fully charged, unplug the charging cable from the power source.
If you want to charge the earbuds from the charging case internal battery, simply replace them in the case. The indicator light to the right of the charge port will glow white to indicate case charging and will turn off when charging is complete.
Warnings
- Do not use this unit for anything other than its intended use.
- Do not puncture, throw, drop, bend, or modify this product.
- Do not throw this product into fire or water.
- Do not short-circuit the battery with any metal or metallic objects.
- Do not expose this product to corrosive liquids such as saltwater.
- Do not operate the unit if it has been wet or moist to prevent electric shock and/or injury to yourself and damage to the unit.
- Do not allow children to play with this product as it is not a toy and may present a choking hazard
- Avoid leaving your device in direct sunlight, such as on the dashboard, console, or seat of a vehicle.
- Do not leave your device, or use your device, in any area where the temperature is likely to drop below 32°F, or may exceed 140° F, such as inside a closed vehicle on a hot day.
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
- Protect your hearing by always listening at a safe level. Prolonged use at elevated volumes may affect your hearing capacity and could result in hearing loss.
- Use the earbuds with this charging case only.
- To avoid damage to the charging case, please only use a USB 5V/1A or higher charger.
- In order to ensure the battery life, charge normally at least once a month.
FCC ID: 2AHN6-HC-AU-BE-110
This device complies with Part 15 of the FCC Rules Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures·
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved could void the user’s authority to operate the equipment.
Warranty
Bytech NY INC. warrants this product to be materially free from defects and workmanship to the original purchaser for a period of 12 months from the original purchase date. Bytech responsibility with regard to this limited warranty shall be limited solely to repair or replacement at its option, of any product which fails during normal consumer use. This warranty does not extend to damage or failure which results from misuse, neglect, accident, alteration, abuse, improper installation, or maintenance. At any time during the 12 months period following the purchase, if the product fails due to defects in material or workmanship, return the defective product (with freight prepaid) with proof of purchase.
WWW.BYTECHINTL.COM
Bytech NY Inc
2585 West 13street
Brooklyn NY 11223
718-449-3700
©2020 BYTECH NY INC.
*All trademarks and copyrights are the property of the respective companies.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>