iHome iW18 PowerValet 2 in 1 Wireless Charger Instructions

June 3, 2024
iHome

iHome iW18 PowerValet 2 in 1 Wireless Charger Instructions
iHome iW18 PowerValet 2 in 1 Wireless Charger

OVERVIEW

Product Overview

REAR CONTROLS

Connect AC adapter to DC Jack, and plug into outlet.
Rear Control

WIRELESS CHARGING

Supports :

  • Qi compatible phones (also works with plastic cases up to 3mm thick)
  • Air Pods with wireless charging case

Place Qi compatible device face up on the charging rest. Charging stat us will be indicated on display :

Rapid blinking icon : Device is not charging (reposition device)
Slow blinking icon : Device is charging
Solid icon: Device is fully charged

Note: Icon may continue to blink slowly when iOS devices are fully charged.

CAUTION: Remove phone’s metal protective case before charging. Do not place magnetic or metal objects on charger during charging. Qi compatible phones with metallic looking finishes will charge normally.

WARNING:

  • Do not ingest the battery, Chemical Burn Hazard. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
  • Keep new and used batteries away from children. If the battery compartment does not close securely, st op using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.”
  • CAUTION – RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THEINSTRUCTIONS.

IMPORTANT SAFETY INSTRUCTIONS

Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.

  1. Do not use this product near water.
  2. Unplug unit and clean only with damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar mater ials can damage the surface of the unit.
  3. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
  4. Heat – This product should bes tuated away from heat sources such as radiators, heat registers, stoves or other appliances (including ampl fiers) that produce heat.
  5. Only use attachments/accessories specified by the manufacturer.
  6. Unplug this product during lightning storms or when unused for long periods of time
  7. Damage Requir ng Service – This product should be serviced by qualified service personnel when:
    • Plug has been damaged.
    • Objects have fallen into or liquid has been spilled into the enclosure.
    • The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
    • The unit exhibits a marked change in performance or doesnot operate normally
  8. No naked flame sources, such as I ghted candles, should be placed on this product.
  9. Attention should be drawn to the environmental aspects of battery disposal. Many electronics retailers now recycle batteries and other electronic components at no charge. To find a drop-off location near you, visit www.call2recycle.com
  10. This product is suitable for use in tropical and/o r moderate climates.

WARNING:

  • To reduce the risk of fire or electric shock, do not expose this product to rain ormoisture
  • Do not dispose of batteries in the household trash or fire
  • The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable.

FCC Information

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s author ty to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a res dental installation. This equipment generates, uses and can radiate radio frequency energy and, f not installed and used in accordance with the instructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occurring a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment should be installed and operated with minimum distance 20cm/8in between the radiat or & your body.

ISED Information

This equipment complies with IC R55-102 radiation exposure limits set forth for an uncontrolled environment.

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference
  2. This device must accept any interference, including interference that may cause undesired operation of the device

The device comply with ISED RF exposure requirement. users can obtain Canadian information on RF exposure and compliance.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
CAN ICES-3 (8) / NMB-3(8), CAN RSS-216 / CNR-216

iW18_new Qi_042221-G

For questions, full instructions, warranty, and additional safety information, please scan the QR code or visit:
www.ihome.com/help/iW18

 © 2021 SDI Technologies, Inc.
All rights reserved

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals