iROCKER Nautical Inflatable Stand Up Paddle Board User Guide
- June 5, 2024
- iROCKER
Table of Contents
iROCKER Nautical Inflatable Stand Up Paddle Board
INFLATING YOUR BOARD
- Before connecting the hose, make sure the inflation valve is in the CLOSED/UP position.
- Connect the hose and set the pump to SETTING 1.
- Begin inflating. (The pressure gauge will not read until the board reaches 7 PSI.)
- Midway through inflation, when pumping becomes more difficult, unscrew the plug from the top cap of pump body.
- When nearing full inflation, set the pump to SETTING 3 and fill to max PSI.
DEFLATING YOUR BOARD
- Make sure the air valve is dry.
- Press firmly on the air valve top for 2 seconds, then twist it to lock into the OPEN/DOWN position.
- Allow air to escape for a few minutes. (Be prepared for a loud rush of air!)
15 PSI = APPROX. 250 PUMPS (VARIES FOR EACH PERSON)
THE VALVE WRENCH IS FOR REPAIR USE ONLY – DO NOT USE IT TO DEFLATE
INSTALLING YOUR FINS
- Lift the lock on the fin box to the OPEN/UP position.
- Insert the front of the fin into the notched section of the fin box. Rock the finback and down until it’s in place, then press the fin lock lever down to secure.
- Make sure the fin is securely attached before paddleboarding.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>