IZINQ PRO250 Top Speed Electric Scooter User Manual

IZINQ PRO250 Top Speed Electric Scooter

The Device & Accessories

Vehicle

Accessories

Assembling the device

1. Set the steering rod and fix with the clamp
2. Set handlebars vertical;
3. Use the hex wrench to tighten the screws on the handlebar.
4. Test the power switch after finish assembling

Power Button
Press the power button (3 sec) to turn on the vehicle. Press and hold the button for 2 seconds to turn off the device. When switched on: press power button to turn on/off the lights; press the power button twice to switch between power modes.

Functions

Mode Indicators

The control panel shows the speed, modes (ECO, D, S), light signal and battery condition.

1. Long press (3 seconds) to turn on / off the scooter.
2. After turning on the scooter, press the power button once to turn on/off the lights.
3. Press the power button twice quickly to change the speed gear ECO/D/S.
4. After starting the scooter, press the power button for 6 times in succession to switch to KM/miles

Charging the scooter

Open the cover and connect the charger. Make sure the cover is placed back after charging.
The indicator on the adapter will signal red if the charging is in progress. The indicator will turn green when charging is completed. The indicator will also signal green in case the adapter is plugged in socket but not connected to the scooter.

Learning to ride the scooter

Please wear a helmet and knee pads when practice

1. Power on and check the battery led light 
2. Stand on the pedal with one leg, hit the ground with the other leg
3. Place both legs on the scooter when the scooter is moving, then press the accelerate button (only accelerate when the scooter speed is beyond 5km/h)
4. Loose the accelerate button to slow down. Energy recovery systems will open itself to slow down. Pull the left braking lever tightly if you want to brake urgently.
5. Lean your body slightly to the left turn left, lean your body slightly to the right to turn right and turn the handlebar slowly.

Safety Instructions

It is not recommended driving on the rain

It is recommended to slightly bend Your knees to better adjust to a rough road. If you are travelling on a rough road, stick to low speed (5-10km/h)

Entering into any room, elevator, etc. be careful not be injured by a door frame.

Please do not add speed when descending a hill

While walking with the scooter, do not press the accelerator.

When driving the scooter, it is recommended to go around various obstacles.

Please do not hang backpacks and other heavy objects on handlebars or place on the board.

When driving it is forbidden to balance on one foot

Preventing dangerous driving

It is forbidden to ride the scooter on a highway road or other roads where motor vehicles drive at a high speed

It is forbidden to sharply turn in residential area with a large flow of passers-by

It is forbidden to drive through puddles which exceeds depth of 2cm

Never rider the scooter with more than one person or hold a child in your arms.

Do not stand on the (rear) fender

Do not touch the disc brake

Do not drive without your hands on the handlebar

Do not ride the scooter up or down steps. Do not jump over obstacles.

Safety Recommendations

An electric scooter is only a device for entertainment, not a vehicle. But once you are driving in public areas, the electric scooter brings certain risks for your safety. For the sake of your safety and the safety of others, you must strictly follow the instructions, outlined in this driving manual.

1. You should understand that if you ride a scooter in a public area, you must comply with all safety recommendations. Also do not forget that there is a possibility of collision, due to violation of pedestrians or vehicles traffic rules. There is also a risk of injury, due to improper operation of the scooter. As in other types of vehicles, the higher the speed of the electric scooter, the larger the braking distance. On some smooth roads, emergency braking may cause skidding of the scooter, loss of balance and even falling. Therefore, during movement of scooter you need to be vigilant, to adhere to an appropriate speed, keep a safe distance from pedestrians and / or from other vehicles. Riding on unfamiliar terrain, keep vigilance and appropriate speed.
2. While riding the scooter, respect the rights of pedestrians. Do not scare them, especially not children. Reduce speed, passing by. If you are moving in the same direction with pedestrians, try to stick to the left side as much as possible (for right-hand traffic countries). If you are moving in the opposite direction, stick to the right and slow down.
3. Please strictly following your country’s road rules for driving and also strictly abide by the instructions and safety recommendations as described in this manual. Violation of the above rules may result in financial expenses, personal injury, occurrence of traffic accidents, legal disputes, conflict and other unpleasant situations. IZINQ Trading b.v. does not bear any direct or indirect liability.
4. To avoid personal injury, do not loan electric scooter to others whom do not know how to drive. Please spend time training before you transfer your scooter to friends, as well as tell them they must be wearing proper protecting gear.
5. Please do inspect the scooter carefully before each use. If you find shattered parts, battery life has decreased obviously, tires leak air or there are signs of excessive wear, uncharacteristic sounds when turning or other abnormal symptoms, please discontinue use of the scooter immediately, don’t drive it reluctantly.

Fold and Transportation

Fold

Make sure the scooter is turned off, hold the front pole, loosen the lock lever and lower the steering rack. Place the steering rack in a horizontal position and secure it by inserting the hook through the special ring which is located on the rear wheel mudguard. To unfold the scooter, disconnect the steering rack lock from the hook of the mudguard and then lift it into a vertical position and lock the lever. Make sure you secure the lock lever.

Transportation

You can transport folded scooter with one hand

Care and Storage

Clean and store Electric Scooter

If you find any stains on the scooter housing, use a soft damp cloth to wipe the vehicle. You can use a toothbrush to clean the scooter from stains, and then wipe it clean with a damp cloth. If you find scratched on parts, made of plastic, use sandpaper or other grinding materials for polishing. Please be careful polishing as it can also cause scratches!

Warning: Do not use alcohol, petrol, kerosene or other corrosive solutions, volatile chemical solvents to clean the vehicle. Otherwise, it will cause serious damage to the scooter body and can disrupt a structure of internal elements. Do not wash the electric scooter under strong pressure of water, make sure the scooter is turned off. In addition, after charging the vehicle, it is necessary to insert the plug back to a charging connector, otherwise you may get an electric shock. Also serious water damage can occur from water entering into this opening.
If you do not use the scooter, store it in a dry, cool place and do not leave the unit for a long time outside. Leaving the device under the sun/in extremely high temperature/over-low temperature can cause rapid aging of the outer body and wheels of the Electric Scooter or reduce battery life.

Maintenance of Electric Scooter battery

Do not use batteries from other brands in order to avoid a dangerous situation;
Do not open or disassemble the battery to prevent electric shock. Avoid contact with metal objects to prevent the occurrence of a short circuit. Otherwise, the battery may malfunction or can injure the user;

Only use the AC adapter that comes in original configuration of the device, to prevent the occurrence of an accident or fire of the vehicle.
Improper disposal of used batteries and accumulators is the cause of severe environmental pollution. Please dispose the batteries in accordance with local laws. Please do not dispose the batteries together with food waste.
Do not store the scooter battery in rooms with temperatures that exceed 50℃ or -20℃ (for example: do not leave the battery of the Scooter and other batteries in
cars in summer time in the hot sun). Do not leave the battery near fire. As a result of these actions the battery may deteriorate, overheat and can even cause inflammation.
If within 30 days the scooter is not used, charge the battery and keep the device in a cool, dry place. Every 60 days you need to charge the battery, otherwise there is the likelihood of its failure, which is not subject to warranty services.
Avoid a full discharge of the device, it will decrease battery life. When using the device at normal room temperature, the battery will be able to ride much greater distance and its performance will be better. But if you use the scooter at temperatures below 0℃, the vehicle performance and permeability decrease.
At -20℃ the range of the scooter is less than in the normal conditions. The range will be half or even less. If the temperature rises, the range of the vehicle will also increase. You can check remaining distance in the Application.

Note: A fully charged scooter runs about 120-180 days of standby time. The battery has a smart chip, that stores information about its charging- discharging. If you are not charging the battery for a long time, it can cause serious damage and it might become impossible to charge the device again. This kind of damage is not included in free warranty service. Caution: Do not disassemble the device by unauthorized people, as there is a risk of electric shock or serious injury as result of a short circuit.

Adjusting the brake disc
If the brake is too tight: use M5 hex wrench and turn the screws of the brake disc tensioner pulley counterclockwise. Then slightly shorten the length of the end of the brake cable. Then tighten the tensioner pulley. If you think that the brake is very loose, loosen the tension pulley, pull the brake cable to slightly increase the length of its ‘tail’. Tighten the tension pulley.

Adjusting the handlebars
Staggering of the steering rack: use the M5 hex wrench, tighten the two screws near the folding mechanism.

Parameters

Motor ParametersRated power(W)Power parametersRated power(W)

Height[1] (cm)

| 106 x 42 x 48
Folded: Length       x
Width x Height(cm)| 106 x 42 x48
weight| Gross weight| 12,5kg
Conditions| Max load| 100
Age| 16-50
Height(cm)| 120-200
Main Parameters| Max speed(km/h)| 25
Possibility in average condition [2] (km)| 20-30
Maximum slope(%)| 14
Suitable area|
Operating temperature range(℃)| -10-40
Temperature        of storage(℃)| -20-45
Waterproof level| IP54
Battery Parameters| Rated

Voltages (VDC)

| 36B
Max voltage of Charging (VDC)| 42B
Rated power(Wh)| 280
Smart battery management system| Stress, insufficient voltage, short circuit, auto sleep/wake up, overheating protection, control of battery using
250
Max power (W)| 500
71
Rated Voltage (VAC)| 100-240B
Rated
Voltage (VDC)| 42V
Rated current (A)| 1.7
Certificate| CCC, RoHs
Charging time (h)| Est. 3.5-5

Warranty

Recommendation: use the packaging for safe transport of the device. We recommend keeping the original packaging within 15 days after receipt of goods.

Warranty terms

panel, rear hub, brakes, disc brakes, (folding) system, fork, front fork governance system bus control, brake cable| 1 year
Accessories| Battery, power supply, brake level, switching gears| 6 months
Exterior parts, that easily wear out| Anti-collision strip, headlights, instrument cover, handle sets, tires, inner tubes, bell, fender, taillights, decorative cover, stand, battery compartment cover, foot pad,

charging port, rubber stopper

| 3 months

Caution:
Hex wrench and other consumable components/ parts have no warranty.

Non – warranty regulations

1. Unauthorized maintenance, misuse, collisions, negligence, abuse, intake, accident. Improper use of non-product accessories, or tear up the modified label, anti-counterfeit mark.
2. The warranty period has expired;
3. Damage, caused by force majeure;
4. Failures, which do not correspond to the List of faults of IZINQ service center;
5. A failure of the device or its components from the List Fault of Faults, which arose in connection with the human factor, and which interfere with normal operation.
6. Failures, that arise in connection with the human factors (including, but not limited to, excessive wetting device, puncture, drop, scratch and damage an outer casing, which have arisen as a result of normal use of goods)
7. If this product is used for commercial purposes without approval of IZINQ Trading b.v., all warranty conditions are not maintained.

List of faults

Name of fault

Electric Scooter| Incorrect motor operation
Problems with operation of the controller
Problems with charger
Problems with battery
In use, the occurrence of cracks, deformation, etc

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>