dji FPV Combo FD1W4K Quadcopter/Drone with Camera User Guide

: June 5, 2024
: DJi

Table of Contents

Introduction
Preparing the Aircraft
Preparing the Goggles
Charging
Linking
Controls
Specifications
Compliance Information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

dji FPV Combo FD1W4K Quadcopter/Drone with Camera User Guide

Introduction

Aircraft

Propellers
Motors
Front LEDs
Landing Gears(Built‐in antennas)
Frame Arm Light
Aircraft StatusIndicators
Gimbal and Camera
Downward Vision System
Infrared Sensing System
Auxiliary Light
Intelligent Flight Battery
Battery Buckles
Power Button
Battery Level LEDs
Battery Port
Forward Vison System
USB‐C Port
microSD Card Slot

Goggles

Antennas
Front Cover
Channel Adjustment Buttons
Channel Display
USB-C Port
microSD Card Slot
Air Intake
Interpupillary Distance (IPD) Slider
Headband Attachment
Foam Padding
Lens
Air Vent
Record Button
Back Button
5D Button
Audio/AV-IN Port
Power Port (DC5.5×2.1)
Link Button

Remote Controller

Power Button
Battery Level Indicator
Lanyard Attachment
Customizable Button
Control Sticks
USB‐C‐Port
Flight Pause Button
Gimbal Dial
Flight Mode Switch
Customizable Switch
Take‐off/Landing Button (non‐M mode) Lock/Unlock Button (M mode)
Shutter/Record Button
Antennas

Preparing the Aircraft

Preparing the Goggles

Charging

Checking Battery Levels and Powering On/Off

Charging

Press once to check the battery level.
Press, then press and hold to turn on/off.

Linking

Press the link button on the goggles.
Press and hold the power button of the aircraft.
The battery level indicator of the aircraft turns solid and display the battery level, the goggles stop beeping when successfully linked and the video display is normal.

Linking

Press and hold the power button of the aircraft.
Press and hold the power button of the remote controller.
Both the battery level indicatorsturn solid and displaythe battery level, and the remote controller stop beeping when successfully linked.

When ready to link, the devices will give the following indication:

Aircraft: the battery level indicator blinks in sequence Goggles: the goggles beep continually Remote controller: the remote controller beeps continually and the battery level indicator blinksin sequence

Controls

Goggles

Controls

Remote Controller

Remote Controller

Specifications

Aircraft (Model: FD1W4K)

5.8G: ≤30 dBm (FCC/SRRC), ≤14 dBm (CE)

Camera
Sensor| 1/2.3’’ CMOS, Effective Pixels: 12M
Lens| FOV: 150°

35mm Format Equivalent: 14.66 mm Aperture: f/2.86

Focus: 0.6 m to ∞

ISO| 100‐3200
Electronic Shutter Speed| 1/8000‐1/60 s
Max Image Size| 3840×2160
Video Resolution| 4K: 3840×2160 50/60p

FHD: 1920×1080 50/60/100/120/200p

Intelligent Flight Battery
Capacity| 2000 mAh
Voltage| 22.2 V(standard)
Type| LiPo 6S
Energy| 45.6 Wh@3C
Charging Temperature| 5°to 40° C
---|---
Max Charging Power| 90 W
Goggles (Model: FGDB28)
Weight| Approx. 420 g(headband and antennas included)
Dimensions| 184×122×110 mm(antennas excluded),

202×126×110 mm(antennas included)

Screen Size| 2 inch×2
Screen Resolution

(Single Screen)

| 1440×810
Operating Frequency| 2.400‐2.4835 GHz；5.725‐5.850 GHz
Transmitter Power (EIRP)| 2.4G: ≤30 dBm (FCC), ≤20 dBm (CE/SRRC/MIC)

5.8G: ≤30 dBm (FCC/SRRC), ≤14 dBm (CE)

Live View Mode| Low Latency Mode(810p 120fps), High Quality Mode (810p 60fps)
Video Format| MP4(Video format: H.264)
Supported Video Play Format| MP4，MOV，MKV

(Video format: H.264; Audio format: AAC‐LC, AAC‐HE, AC‐3, MP3)

(unobstructed, free of interference)

| 2.4G: 8 km (FCC)；4 km (CE)

5.8G: 8 km (FCC)；1 km (CE)

Transmitter Power (EIRP)| 2.4G: ≤30 dBm (FCC), ≤20 dBm (CE/SRRC/MIC)

5.8G: ≤30 dBm (FCC/SRRC), ≤14 dBm (CE)

Operating Current/Voltage| /

Compliance Information

FCC ComplianceNotice

This device complies with Part 15 of the FCC Rules. Operation issubject to the following twoconditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

ISED Warning

This device contains licence‐exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence‐exempt RSS(s). Operation is subject to the following two conditions: (1)This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device.

KCC Warning Message

NCC Warning Message

EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com/euro‐compliance

EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE Environmentally friendly disposal. cal appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons. is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.

RF Exposure Information
SAR tests are conducted using standard operating positions accepted by the FCC/ ISEDC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value.
Before a new model device is a available for sale to the public, it must be tested and certified to the FCC/ ISEDC that it does not exceed the exposure limit established by the FCC/ ISEDC, Tests for each device are performed in positions and locations as required by the FCC/ ISEDC.
For head/Extremity, this model device has been tested and meets the FCC / ISEDC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal.
Non‐compliance with the above restrictions may resultin violation of RF exposure guidelines.