HIKVISION DS-PDCL12DT-EG2 Wired Dual-Tech Ceiling Detector User Manual
- June 5, 2024
- Hikvision
Table of Contents
DS-PDCL12DT-EG2
Wired Dual-Tech Ceiling Detector
User Manual
50131-2-4:2020
50131-1+A1+A2+A3
Environment Class II
Security Grade2
Tested by TÜV Rheinland
UD26464B
Appearance
- PIR sensitivity jumper
- LED jumper
- Alarm pin
- Terminals
- Tamper pin
- Tamper
- PIR sensor
- LED indicator
- Microwave sensor
Installation
Resistor Wiring
Relay Status
| Normal| PIR & Microwave Alarm| PIR Fault| Microwave Fault| Tamper
---|---|---|---|---|---
Alarm Relay| Close| Open| Open| Close| Close
Method 1: Use the jumper to select EOL (End of Line) resistance on
TAMPER/ALARM pins.
Method 2: Add the resistor to TAMPER/ALARM wiring ports.
Note: If EOL wiring is not used, leave the jumpers OFF. Do not force the jumper if it is not matched the pin. Method 1 & 2 should not be used on the ALARM/TAMPER at the same time.
- Alarm Resistance: 1K, 2K2, 4K7, 5K6, 6K8
- Tamper Resistance: 1K, 2K2, 4K7, 5K6
Connection Type
Note: The resistor must be connected in series with one end of the detector.
- Normally Closed
- Single End of Line Wiring
- Double End of Line Wiring
Detection Range
Powering On
After powering on, the indicator flashes rapidly. Once the detector self-test is completed, the LED indicator will go out until the detector detects movement.
Specification
| Detection method | Passive Infrared, Microwave |
|---|---|
| Detection range | 12 m |
| Detection angle | 360° |
| Detection zones | 172 |
| Detectable speed | 0.3 to 2 m/s |
| Sensitivity | Auto, Low |
| White light filter | 6500 lux |
| Microwave frequency | 24 GHz(24 to 24.25 GHz) |
| Digital temperature compensation | Support |
| Creep zone protection | Support |
| Digital processing | Support |
| Sealed optics | Support |
| Tamper protection | Front |
| LED indicator | Green(PI R), Red(Microwave), Blue(Alarm) |
| Power consumption | 100 mA Max |
| Power supply | 9 to 16 VDC |
| Typical voltage | 12 VDC |
| Operation temperature | -10 °C to 55 °C (14 °F to 131 °F) |
| Storage temperature | -20 °C to 60 °C (-4 °F to 140 °F) |
| Operation humidity | 10% to 90% |
| Dimension | 4120 mm x 33.2 mm |
| Weight | 138 g |
| Mounting height | 2.4 to 4 m |
| Mounting method | Ceiling |
| Application scenario | Indoor |
Please use the power supplies to comply with the requirements of EN 50131-6 at
the appropriate grade and environmental class.
Please do not obscure the detector’s field of view partially or completely.
|
|
©2021 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved.
About this Manual
The Manual includes instructions for using and managing the Product. Pictures,
charts, images, and all other information hereinafter are for description and
explanation only.
The information
contained in the Manual is subject to change, without notice, due to firmware
updates or other reasons. Please find the latest version of this Manual on the
Hikvision website
(https://www.hikvision.com/).
Please use this Manual with the guidance and assistance of professionals
trained in supporting the Product.
and other Hikvision trademarks and logos are the properties of Hikvision in
various jurisdictions. Other trademarks and logos mentioned are the properties
of their respective owners.
Disclaimer
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS MANUAL AND THE PRODUCT
DESCRIBED, WITH ITS HARDWARE, SOFTWARE, AND FIRMWARE, ARE PROVIDED “AS IS” AND
“WITH ALL FAULTS AND ERRORS”. HIKVISION MAKES NO WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY,
OR FITNESS FOR A PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT YOUR
OWN RISK. IN NO EVENT WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL,
CONSEQUENTIAL, INCIDENTAL, OR INDIRECT DAMAGES, INCLUDING, AMONG OTHERS,
DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA,
CORRUPTION OF SYSTEMS, OR LOSS OF DOCUMENTATION, WHETHER BASED ON BREACH OF
CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN
CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF
THE POSSIBILITY OF SUCH DAMAGES OR LOSS. YOU ACKNOWLEDGE THAT THE NATURE OF
THE INTERNET PROVIDES FOR INHERENT SECURITY RISKS, AND HIKVISION SHALL NOT
TAKE ANY RESPONSIBILITY FOR ABNORMAL OPERATION, PRIVACY LEAKAGE, OR OTHER
DAMAGES RESULTING FROM CYBER-ATTACKS, HACKER ATTACKS, VIRUS INFECTION, OR
OTHER INTERNET SECURITY RISKS; HOWEVER, HIKVISION WILL PROVIDE TIMELY
TECHNICAL SUPPORT IF REQUIRED. YOU AGREE TO USE THIS PRODUCT IN COMPLIANCE
WITH ALL APPLICABLE LAWS, AND YOU ARE SOLELY RESPONSIBLE FOR ENSURING THAT
YOUR USE CONFORMS TO THE APPLICABLE LAW. ESPECIALLY, YOU ARE RESPONSIBLE, FOR
USING THIS PRODUCT IN A MANNER THAT DOES NOT INFRINGE ON THE RIGHTS OF THIRD
PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS OF PUBLICITY, INTELLECTUAL
PROPERTY RIGHTS, DATA PROTECTION, AND OTHER PRIVACY RIGHTS. YOU SHALL NOT USE
THIS PRODUCT FOR ANY PROHIBITED END-USES, INCLUDING THE DEVELOPMENT OR
PRODUCTION OF WEAPONS OF MASS DESTRUCTION, THE DEVELOPMENT OR PRODUCTION OF
CHEMICAL OR BIOLOGICAL WEAPONS, ANY ACTIVITIES IN THE CONTEXT RELATED TO ANY
NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL CYCLE, OR IN SUPPORT OF HUMAN RIGHTS
ABUSES. IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE
LAW, THE LATTER PREVAILS.
This product and – if applicable – the supplied accessories too are marked with “CE” and comply therefore with the applicable harmonized European standards listed under the RE Directive 2014/53/EU, the EMC Directive 2014/30/EU, the LVD Directive 2014/35/EU, the RoHS Directive 2011/65/EU
2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info
2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as unsorted municipal waste in the European Union. See the product documentation for specific battery information. The battery is marked with this symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling, return the battery to your supplier or to a designated collection point. For more information see: www.recyclethis.info
FCC Information
Please take attention that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
INSTALLATION CAUTION
1. Install the equipment according to the instructions in this manual.
2. To prevent injury, this equipment must be securely attached to the
floor/wall in accordance with the installation instructions.
Hangzhou Hikvision Digital Technology CO., Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
Documents / Resources
|
HIKVISION DS-PDCL12DT-EG2 Wired Dual-Tech Ceiling
Detector
[pdf] User Manual
D0512040, 2ADTD-D0512040, 2ADTDD0512040, DS-PDCL12DT-EG2 Wired Dual-Tech
Ceiling Detector, Wired Dual-Tech Ceiling Detector
---|---
|
HIKVISION DS-PDCL12DT-EG2 Wired Dual-Tech Ceiling
Detector
[pdf] User Manual
DS-PDCL12DT-EG2, Wired Dual-Tech Ceiling Detector, Dual-Tech Ceiling Detector,
Ceiling Detector, DS-PDCL12DT-EG2, Detector
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>