JVA ST113 Large Solar Kit Instruction Manual
- June 9, 2024
- JVA
Table of Contents
JVA ST113 Large Solar Kit
Large Solar Kit
Installation Instructions
-
Unpack the solar kit from it’s packaging. Look inside the packaging for a set of U-Bolts.
-
Remove the U-Bolts from the zip lock bag and mount it to the top and bottom panel of the bracket.
- (A ) U-Boltx2
- (B) Top or Bottom Panel
- (C) Washers x4
- (D) Spring Washers x4
- (E) Hex Nut x4
-
Mark the mounting pole. This is where the top U-bolt will be.
-
Slide the U-bolts over the pole and tighten when the top bolt aligns with previous marking.
-
Loosen the 6 bolts on the inside of the frame. Do NOT completely remove the bolts.
-
Lift the bottom of the Solar Panel until the attached arms holding it are angled at 90 degrees. Tighten all 6 bolts again from and face the panel north.
-
If you have a JVA Energiser it can be installed between the solar panel and the pole. There are 2 mounting screws that can be used to hang the energizer up.
-
If your JVA energiser is fitted, plug it into the solar panel lead. The energiser aligator leads and plug pack will be unsued (left over).
-
Attach the red and black ring terminals to the battery
To find a battery that will suit you, visit our website: https://www.jva- fence.com.au/solar.php -
Alternative Wiring:
Alternatively, the energiser can be connected to the battery directly using the alligator leads that came with the energiser.
The JVA Logo is a Trademark of JVA Technologies Pty Ltd JVA Technologies