Shenzhen View Lighting Technology HO2 Mobile Charging Station User Manual
- June 3, 2024
- Shenzhen View Lighting Technology
Table of Contents
Shenzhen View Lighting Technology HO2 Mobile Charging Station User Manual
Connect to Power Adapter
System Specifications
Product model :H02
Input :5V/3A
Output :10W/5W/2.5(For Match)
Mobile Phone Charging Right Way
- The charging board blue-green indicator is steady on for 3 seconds and then turns off. The charging board enters the standby state
- When the LED indicator turns blue, the device is being charged The blue light goes off in 20 seconds
Compatibility Table
-
Smart phone [ToApple]iPhone6/iPhone6Plus/iPhone6s/iPhone6sPlus/iPhone7/iPhone7Plus/ iPhone8/iPhone8Plus/iPhoneX/iPhoneXS/iPhoneXSMax/iPhoneXR/iPhonel 1/ iPhone11Pro/iPhone11ProMax/iPhoneSE2/iPhone12/iPhone12mini/iPhone12Pro/ iPhonel 2ProMax/iPhonel 3/iPhonel 3mini/iPhonel 3Pro/iPhonel 3ProMax iPhone 14/ iPhone 14 pro/ iPhone 14 proMax
-
Applicable equipment watch
iwatch2/3/4/5/6/SE/7/8 -
Applicable Device Earphone
Airpods pro/Airpods pro 2/Airpods 3/Airpods 2(wireless case)
Product Usage
There are 2 ways to open the contact port of the watch:(1) Push the contact port upwards to stand up or (2) Push it up from the back with your finger
There are two steps to open the contact port of the Bluetooth headset: (3)Press down to erect the contact port. 4 Use your finger to fully erect the contact port.
There are two steps to open the mobile phone contact port: (5) Press down to erect the contact port. (6) Use your finger to completely erect the contact port. (7) Turn it to the Angle below
Notes:
Please pay attention to the following issues,otherwise it may cause abnormal
charging,high charging temperature, intermittent charging,or even not
charging.
- Please put the device at the center of charge area to ensure stable charging. (as picture shows)
- The Watch device has overheating protection. When the temperature reaches 40 degrees,the charging will be stopped automatically.When the temperature turns normal,charging keeps continue.
- Do not put cases made of metal and attachments such as magnets, cards,and grips around the devices,which will interfere with charging.
- The lower temperature,the faster charging speed.The charging speed is faster in winter than in summer.
- Do not charge in high temperature and humidity to avoid damage the circuit
- Put it at the place that children can’t reach to avoid to unnecessary accidents.
About the FCC
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.This equipment shauld be installed and operated with
minimum distance 20cm between the radiator & your body.
This device complies with part 15 of the FCC rules, operation is subject to
the following two conditions:
- this device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmfulinterference in aresidential installation.This equipment generates uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation if this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on.
The user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.