Shenzhen View Lighting Technology F2 Portable Apple Watch Charger User Manual
- June 9, 2024
- Shenzhen View Lighting Technology
Table of Contents
Shenzhen View Lighting Technology F2 Portable Apple Watch Charger
This product is designed in a portable design, we wanted to make charging your
Apple Watch utterly effortless.
Simply hold the connector near the back of the watch, where magnets cause it
to snap into place automatically.
It charges all Apple Watch models and sizes.You can give emergency power to
the Apple Watch when you are outdoors.
Tech Specs
- Input: 5V / 1A
- Output: 5V/1A
- Capacity: 1200mAh
- Battery Type: Polymer battery
- Product Size: 78x37x12mm
- FCC ID： 2A7OT-F2
Packing list
- Power Bank 1pcs
- Charging Cable 1 pcs
- User Manual 1pcs
Schematic Diagram
- Click the power button to turn on the power output, and the battery indicator light turns on, and the Apple Watch can be attached to the magnetic charging position for charging. If the charger does not detect the AppleWatch within 45 seconds, it will automatically turn off.
- Double-click the power button to turn off the power output.
- Four LED indicators to indicate the current battery capacity,one to four LEDs indicate the current power is 25%,50%,75%,100%.
- When only one LED is flashing, it indicates that the battery is too low and needs to be charged.Plug in the charging cable, connect the charger, and the battery indicator light starts flashing to indicate that it is charging. The battery indicator shows the current charging capacity.When all four LEDs are on, the battery is fully charged.
- After the Apple Watch is fully charged, you need to remove the watch and double-click the power button to turn off the power output.
Attention: The magnet attraction of the charging position is the role of the Apple Watch in aligning the position when charging. It can’t be used as a function to fix the watch. Please put it horizontally and do not move when charging. Do not hang or sway, otherwise the Apple Watch may fall off and cause damage.
- Please don’t dismount and remodel the product.
- Pay attention to water-proof, moisture-proof.
- Please don’t charge in hot environment.
- Please stop to use immediately if battery is bulge, leaking or smell.
- Please stop charging immediately when the product temperature is high.
FCC warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure require ment. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>