abinGO BT30NC Pro Wireless Noise Canceling Headset User Manual
- June 5, 2024
- abinGO
Table of Contents
abinGO BT30NC Pro Wireless Noise Canceling Headset
Overview
Parts
Bluetooth
Media
Specification
- Wireless Version: 5.0
- Working Distance: up to 1 OM
- Impedance:320 ±15%
- Driver: 40mm
- Frequency :20Hz-20KHz
- Working time(Wireless ANC): hours
- Working time(ANC only): hours
- Working time(Wireless only): hours
- Standby time: up to 200 hours
- Battery: mAh, Rechargeable
- non-replaceable Lithium
- Power requirement 5v/1A
Instructions
- Noise Reduction: Turn on ANC Button. Start ANC function. The noise reduction is 28db+2db@50-1000HZ
- Power On/Pairing: Press the Multi-functional button for 4s until the red-blue LED indicator flashes alternatively every 0.5s, it gets into pairing mode and the headphone emits “Power On”
- Connected: when connected, a blue LED indicator flashes every lQs, and the headphone emits “Connected.
- Music Play: start a music player to play music.
- Play/Pause: press the Mufti-functional button to play/pause music.
- Volume Up/Down: press “VOL+/VOL-” to increase/decrease volume, when it reaches maximum volume, it emits “maximum volume”, when it decreases to minimum volume, it emits “minimum volume”.
- last song/next song: When playing, long press + for the next song, long press – for the last song
- Incoming cal l: when there is an incoming ca ll, it rings and blue LED indicator flashes every 0.5s.
- Answer/End: press the Multi-functional button to answer the incoming call blue LED indicator flashes every 10s, press it again to end call.
- Reject Calls: press & hold Multi-functional button for 2s to reject the incoming call.
- Siri double presses the multiple functions; button.
- Power Off: press & hold the Multi-functional button for ls until red LED indicator flashes three times.
- When battery voltage is lower than 3.3v, red LED indicator flashes every 10s. it emits “Battery Low”
- When charging, the headphone automatically turns off and red LED indicator lights on. Blue LED ind icator wi ll light on when fu lly charged
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: This device may not cause harmful interference,
and This device must accept any interference received, including interference
that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>