Razor W13112144011 Power Core E90 Sprint Brake Lever Replacement Procedures Instruction Manual
- June 5, 2024
- Razor
Table of Contents
POWER CORE E90 SPRINT BRAKE LEVER
REPLACEMENT PROCEDURES
PART # W13112144011
Required Tools: (Not included)
A. 5 mm Allen wrench
B. 4 mm Allen wrench
C. 8 mm wrench
D. Long needle pliers
E. Flat screwdriver
WARNING
CAUTION: To avoid potential shock or another injury, turn the power switch OFF and disconnect the charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Step 1
Using a 5 mm Allen wrench, loosen the bolts on the collar clamp. Remove collar
clamp and set aside.
Step 2
Disconnect the brake lever switch from the controller.
Step 3
Using a 4 mm Allen wrench and an 8 mm wrench, loosen the bolt that holds the
brake cable.
Step 4
Using long needle pliers, squeeze the end cap from the brake cable. Pull the
brake cable out from the brake barrel guide.
Step 5
Using a 5mm Allen wrench, loosen the bolt from the brake lever. Pull the lever
away from the grip and pull the grip from the handlebar.
Step 6
Using a flat screwdriver, remove the grommet from the handlebar and pull the
wire out from the handlebar.
Step 7
Reverse the steps.
ATTENTION: Charge battery 12 hours before using.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00am – 5:00pm Pacific Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>