GRUNDIG HS 7030 Hair Styler Straight and Curls User Manual

June 5, 2024
GRUNDIG

Hair Styler Straight & Curls
User Manual

HS 7030

01M-8818771600-5220-02

|
---|---
OPERATION| CLEANING AND CARE

SAFETY _

Please read these instructions carefully before using the device! Please follow all the safety instructions! Damage may be caused by using the device incorrectly.

  • Please keep these instructions for future reference. In the event that the device is passed on to a third party, these instructions must also be passed on to the new owner or user.
  • This device is intended for domestic use only.
  • Never use the device in a bath or shower, over a sink, or in a basin filled with water. Never use wet hands.
  • Do not immerse the device in water or allow contact with water, even when cleaning the device.
  • If you use this device in the bathroom, it must be unplugged after use, as water near the device can still be hazardous even when the device has been turned off.
  • Always unplug the device before cleaning it or carrying out any maintenance.
  •  For additional protection, install an RCD (Residual Current Device) with a residual current rating no higher than 30 mA in the circuit. Ask your electrician about this.
  • The device must never be covered by anything, e.g. towels.
  • During operation, never place the device on any soft upholstery, cushions or blankets, paper or cardboard, plastics, or combustible or unprotected polished surfaces.
  •  The device can become very hot. Never leave hair between hot styling plates for more than a few seconds.
  •  Never let the hot styling plates touch your face, neck, or scalp. Do not touch with bare hands.
  • Unplug the device immediately after use. Do not unplug by pulling on the power cord. Place the device on a heat-resistant surface and allow it to cool down.
  • Do not use the device if there is visible damage to it.
  • Our GRUNDIG household appliances all comply with current valid safety standards. If there is any damage to the device or to its power cord, it must be repaired by a  Service Centre or replaced, to avoid any potential risk of danger. Any repair performed incorrectly by an unqualified person could present safety risks and endanger the user.
  • The cable must be positioned so that there is no risk of accidentally pulling on it or tripping over it.
  • Always keep the device out of reach of children.
  • In the event that this device is to be used by children aged 8 and over or by persons with reduced physical, sensory or mental capabilities or with a lack of experience or knowledge, the user must be supervised or instructed regarding the safe use of the device and must have an understanding of the consequent potential risks of danger.  children must not play with this device. In the event that children carry out the cleaning of the device or perform user maintenance, they must be fully supervised.
  • When the device is on, it must never be left unattended.
  • Never open the device, under any circumstances. No liability shall be accepted for damage caused by incorrect use.
  • Please check that the voltage on the rating plate (on the device handle) corresponds to the local power supply voltage. The only way to disconnect the device from the power supply is to unplug it.
  • Never wrap the power cord around the device.
  • Never use the device on or near combustible or flammable areas or furniture. Do not allow the device to be touched or covered by flammable materials, such as curtains,  fabric, walls, etc. Ensure that the device is always kept at a safe distance away from flammable materials and furniture.
  • GRUNDIG HS 7030 Hair Styler Straight and Curls - fig6WARNING Do not use this appliance near bathtubs, showers, basins, or other vessels containing water.
  • Burn hazard. Keep appliances out of reach from young children, particularly during use and cool down.
  • Always place the appliance with the stand, if any, on a heat-resistant, stable flat surface.

AT A GLANCE

Dear Customer,
Congratulations on purchasing your new Hair Styler Straight & Curls HS 7030.
Please read the following instructions carefully to ensure that you will be able to go on using your high-quality GRUNDIG product for many years.

A Responsible Approach!

GRUNDIG is committed to contractually agreed social working conditions with fair wages for both its own employees and its suppliers, to efficient use of raw materials,  continuously reducing waste by several tonnes of plastic every year, and ensuring that all our accessories remain available for at least 5 years. For a future worth living. Grundig.

Meanings of the symbols

The following symbols are used in various sections of this manual:

| Important information and useful hints about usage.
---|---
| WARNING: Warnings against dangerous situations concerning the security of life and property.
| Electrical insulation class.

Controls and parts
See the picture on page 3.

A n On/Off button
B Temperature touch control
C Hair protection mode activation button
D LCD Display
E Ceramic-coated styling plates
F Protective cover for plates
G Plate locking button
H Power cord with hanging lug

Hair protection mode C
The intelligent sensor analyzes the hair 30 times per minute and selects the optimal temperature for gentle styling and ideal heat protection.

OPERATING INSTRUCTIONS

Hair structure
The device allows for individual temperature settings. The following individual settings are recommended to work best with the specific hair structures listed:

  •  For fine, brittle, color-treated, blonde hair: 130 °C to 170 °C
  • For normal hair: 170 °C to 210 °C
  • For strong, resistant, thick hair: 210 °C to 230 °C

Auto Shut Off

  • The device will switch off automatically one hour after you finish using it.

Styling Possibilities
With your Hair Styler HS 7030, you can:
– Straighten hair
– Style the ends (turning in or out)
– Form soft cascading waves and curls

Temperature setting

  1. If you touch the temperature selection B and move it from a lower to a higher setting, the corresponding temperature will flash on the LCD display. Once the styling plates reach the required temperature, the temperature display stops flashing and is on continuously.
  2. If you touch the temperature selection B and move it from a higher to a lower setting, the corresponding temperature will flash on the LCD display. The temperature display will light continuously once the plates have reached the required temperature.

Lock Setting

The temperature setting is locked automatically 5 seconds after the required temperature has been set. This means that the temperature setting cannot be changed once the device is in use. If you want to change the temperature setting, simply press and hold the +/- button for 2 seconds to unlock the temperature setting.

INFORMATION

Cleaning and Care

  1. Switch off the device and unplug H from the power supply.
  2. Before cleaning, allow the device to cool down completely. The device can become very hot; it may take up to 45 minutes to cool down.
  3. Clean the housing and the styling plates only using a soft damp cloth.

Storage

  • If the device is not used for a long time, it must be stored carefully.
  • Ensure that the device is unplugged from the power supply, has cooled down completely, and is dry.
  • Lock the device’s styling plates in position, using the plate locking button G.
  • Attach the protective cover supplied. This protective cover will prevent any scratching of the styling plates.
  • Do not wrap the power cord around the device.
  • Store in a cool dry place.
  • Ensure that the device is always kept out of reach of children.

Tips for energy saving

Turn off and unplug the appliance after each use.

Compliance with the WEEE Directive and Disposing of the Waste Product:

This product complies with the requirements of the EU-WEEE directive (2012/19/EU). This product carries a classification symbol for waste electrical and electronic equipment (WEEE).
**** This symbol indicates that the product must not be disposed of with ordinary household waste at the end of its operating lifetime. Waste electrical and electronic equipment must be taken to the appropriate official recycling collection points. For details of these collection points, please contact your local council or the retailer from whom you purchased your device.

The contribution to environmental protection made by every household is important. Disposing of waste equipment appropriately will help to prevent harmful effects on the
environment and human health

Compliance with RoHS requirements:
The product that you have purchased complies with the EU RoHS Directive (2011/65/EU). It contains no hazardous or prohibited materials as specified in the terms of the directive.

Packaging Information

The product packaging has been manufactured from recyclable materials in accordance with our national legislation. Please do not dispose of these packaging materials with ordinary household waste or other refuse. Please take them to a collection point for packaging materials, provided by your local authority.

Technical Specifications

Power supply:
100–240 V~, 50–60 Hz
Output : 52–54 W
Electrical insulation class: II
Technical and design modifications reserved.

For commissioning, general use, and cleaning, please observe the instructions on pages 4-5 of this operating manual

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals