beamZ 153.705 V1.1 Whirlwind 3-In-1 LED Effect DMX User Guide
- June 5, 2024
- beamZ
Table of Contents
beamZ 153.705 V1.1 Whirlwind 3-In-1 LED Effect DMX
POWER SUPPLY
The label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
WARNING: Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to avoid the risk of electrocution or fire.
DMX512 CONTROL
If you are using a standard DMX controller, you can connect the DMX output of
the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until
all units are connected.
CAUTION: At the last unit, you must close the DMX line with a terminating
resistor. Take an XLR connector and solder a 120 Ohm resistor between signal
(-) and signal (+) and connect it to the DMX output of the last unit in the
line.
REMOTE CONTROLLER
CONTROL MENU
DMX CHANNELS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>