RODE Wireless Go Compact Wireless Microphone System User Guide
- June 5, 2024
- Rode
Table of Contents
RODE Wireless Go Compact Wireless Microphone System
OVERVIEW
The Wireless Go is a compact wireless microphone system that operates in the 2.4GHz spectrum. The kit includes a transmitter with an internal microphone and a receiver with 3.5mm TRS output.
SET UP
Press and hold the power button for 3 seconds to turn on the RX (receiver).
Press and hold the power button for 3 seconds to turn on the TX (transmitter).
The units will already be paired and start transmitting audio, the transmitter
will be using the internal microphone.
Clip-on the supplied windshield if required If desired, plug in a compatible
external microphone and the TX will automatically switch the audio input.
Connect the 3.5mm TRS output of the RX to a camera’s microphone input or
similar audio device.
TRANSMITTER – TX
Power Button
- Press and hold the power button for 3 seconds to turn on the unit
- Press and hold the power button for 3 seconds to turn off the unit
- Single press to turn on when the device is in charging mode
Internal Microphone
- The transmitter will use the internal microphone if there is not an external microphone plugged in
- Onboard processing optimized for the human voice
Microphone Input
- Standard 3.5mm TRS microphone input
- Supplies 2.8V plug-in power for compatible microphones “Power” and “Link” LED’s
- Power LED
- Solid = internal battery is above 20%
- Slow flash = internal battery is below 20%
- Rapid flash = internal battery is below 10%
- Double flash = Charging through USB (solid when 100% charge is reached)
Link LED
- Solid = Paired and transmitting to an RX
- Slow flash = Not connected to the RX or out of range Rapid flash = in pairing mode (will time out after 3 seconds)
- Off = TX is in charging mode and not transmitting to a receiver
USB-C
- Standardized USB-C port
- Used for charging with USB power supplies and is able to connect to a computer for future firmware updates
- The power LED will display charging mode if the unit is plugged into power while off, a quick single press the power button will turn on the TX Wireless Go User Guide V01
RECEIVER – RX
Power Button
Press and hold the power button for 3 seconds to turn on the unit
Press and hold the power button for 3 seconds to turn off the unit
Single press to turn on when the device is in charging mode
“dB” Button
Press the “dB” button to cycle through the three audio output levels (0dB,
-12dB, -24dB)
Set the level according to the requirements of the device receiving the audio.
I.e. portable recorder, smartphone, camera, etc.
The RX will remember the selection chosen for future use
Link Button
The RX and TX will come pre-paired out of the box If pairing is required
Press and hold the button for 3 seconds
The signal strength icon on the screen will start flashing
Single press the power button on the TX
The TX and RX should pair immediately
Audio output
Standard 3.5mm TRS output
Multi-mono signal
USB-C
Standardized USB-C port
Used for charging with USB power supplies and is able to connect to a computer
for future firmware updates
The screen will display charging mode if the unit is plugged into power while
off, a quick single press of the power button will turn on the RX
Wireless Go User Guide V01
SPECIFICATIONS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>