myFirst 3DPen Starter Kit User Manual

myFirst 3DPen Starter Kit

INSTRUCTION

1. Filament hole
2. Charging port
3. Power/Speed button
4. Position 0: Power off
5. Position 1: Low speed
6. Position 2: High speed

Operation Instruction

1.  Switch the Power/Speed button to position 1 or 2, the indicator will flicker, and heating will start automatically.
2.  When the indicator stops flickering, press the Start/Stop button to start loading. Load filament into the filament hole till it comes out from the nozzle. Press again to stop.
3.  Press and hold the Eject/Temperature button once to adjust to high temperature of the 3dPen. Indicator will turn red. Press and hold the Eject/Temperature button again to lower temperature. Indicator will turn green.
4.  Click the Eject/Temperature button once to remove filament. The removal process will last 10 seconds. Stop removal process by pressing the button during the process.
5. Switch the Power/Speed button to position 0 to power off the 3dPen, the filament will be removed automatically after powered off. Note: after 5 minutes without operation, device will be powered off automatically. When the indicator quickly flickers, charge the device (Use the adapter with an output of 5V 1A or 5V 2A).
   Note: Underpowered off mode, the indicator will turn red consistently during recharging, and it will turn green after fully charged; Under power on mode, the indicator will quickly flicker for three times to indicate that charging has started after plugging in the USB cable, after that the light will indicate its working status again. When using while charging, please use 5V 2A power adapter.

WARNING

• This device is suitable for children over 6 years old and above.
• DO NOT PULL the filament from the rear. To remove, click the eject button to reverse the filament. Failing to do so will cause the device to get stuck and malfunction.
• DO NOT REINSERT a filament after removing. You must snipe the filament before reinserting into myFirst 3dPen.
• DO NOT reuse expanded filaments.
• DO NOT use filaments offered by unapproved manufacturers. Our filaments are specially formulated to be low heat and designed specifically for myFirst 3dPen.

Troubleshooting

Please follow the below instruction in case of any defect.

The heating indicator cannot be powered on

| Battery is fully used up| Charge device
Motherboard defective| Repair or replace the motherboard

No filament coming out from nozzle

| Nozzle blocked| Replace the nozzle set
No heat| Replace the nozzle set or check the motherboard
Gear slips| Back wire, clean gear, cut of the damaged supplies
Failed to load filament| Eject filament and cut the end of filament properly
Motherboard defective| Repair or replace the motherboard
No heat| Heating part defective| Replace the nozzle set

PRODUCT EXAMPLES

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>