myFirst Drone Play Air Hover Drone User Manual
- June 5, 2024
- myFirst
Table of Contents
myFirst Drone Play Air Hover Drone
READ BEFORE USING
When using this product, unexpected accidents such as injury to others or
damage to things may occur due to flying conditions or
steering errors. Be sure to read the included start guide and web instruction
manual carefully before using this product and strictly observe the
precautions.
Notes
- Avoid playing near glass, dark objects, or a strong light source.
- Do not use the drone in areas with high wind speeds.
- Do not use the drone in a narrow or cluttered environment.
- Product to be used indoors. When using outdoor, the supervision of an adult is needed
- The recommended age to operate myFirst Drone is 6 years or older.
- Children below the age of 6 must be supervised by a parent or an adult.
- Do not fly near children under the age group.
- If the product is damaged due to an operational error, the repair costs will be borne by the customer. Damage to the drone after the flight is not covered by the warranty.
- Do not use operate the drone near fans or air conditioners. The drone’s flight ability may be affected by the wind and may not fly properly. Please close the windows before playing.
- Do not charge or store the device near an open flame, or in a hot and humid environment. Avoid direct sunlight and keep it out of reach of children.
- Avoid disassembling, or putting in water or fire.
- We do not take any responsibility for any accidents caused by failure to follow the notes and instructions.
Power on
Press and hold the ‘Power button for 1 second to turn on the drone. When the
LED turns green, it is ready to play.
Power off
Press and hold the ‘Power’ button for 2 seconds to turn off the drone.
The LED light should go off when the drone is off.
Charging the drone
It takes 40 minutes to fully charge the drone. During charging, the light on
the USB charger is turned on. When the battery is full,
the LED light on the USB charger will turn off. A red LED on the drone
indicates a low battery.
Adjusting the speed
Make sure the drone is turned on. Press the ‘Power’ button to toggle between
normal and fast speed.
- Green LED light = Normal speed
- Blue LED light = Fast speed
Calibration
If your drone is flying abnormally, please calibrate the drone.
- Turn the drone over and press the ‘Power’ button 3 times. TheThe LED light should begin flashing.
- . Quickly turn the drone back to its normal position and place it on flat ground.
- Drone calibration is complete when the LED light stays solid.
How to play
With the drone turned on, place the drone on the palm of an extended arm.
Lower your arm in a swift movement. The drone will start flying automatically.
When the drone detects an object, it will move in the opposite direction.
Avoid playing near glass, dark objects, or a strong light source.
Note: The drone will ascend and hover in the air. When the
drone’sproximity sensors are not activated for 2 seconds, it will
automatically descend to its previous height.
To stop, grab the drone and flip it over as illustrated.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>