DYNATRAP DT162 Mosquito and Insect Trap with EZ Disposal Basket Owner’s Manual

June 5, 2024
DynaTrap

DT162 Mosquito and Insect Trap with
EZ Disposal Basket
Owner’s Manual

Thank you for purchasing the DynaTrap® Insect Trap!
This product may be covered by one or more U.S. patents or pending patent applications. See www.DynaTrap.com/patents

IMPORTANT: READ CAREFULLY IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
WARNING: When using electric appliances, basic precautions should always be followed, including the following:

  1. Please read all instructions before using the DynaTrap® Insect Trap and keep it for future reference.
  2. To disconnect, remove the plug from the outlet.
  3. To reduce the risk of injury from moving parts or electric shock, disconnect the plug before servicing or cleaning.
  4. Always unplug before replacing the lamp. Replace with same type rated 1.8-Watt UV-Light LED bulb, DynaTrap® model 11020.
  5. Do not position the unit near heat, gas, oil or other flammable materials.
  6. Place out of reach from children.
  7. To reduce the risk of electrical shock, do not put the appliance in water or other liquid.
  8. Never operate this product if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water or other liquid.
  9. Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
  10. Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
  11. Collected insects within the unit may contribute to fire, so clean insects from the unit frequently.
  12. Do not clean this product with water spray. Do not place it where it can fall into the water, or near flammable materials.
  13. Do not touch the fan while in motion.
  14. Do not abuse the cord—Never carry or hang the unit by a cord or yank it to disconnect from the receptacle. Keep the cord away from sharp edges.
  15. If using outdoors, use only extension cords with a tag stating, “Suitable for Use with Outdoor Appliances.”
  16. Use only extension cords that have plugs and receptacles that match the product plug. Replace or repair damaged cords.
  17. Only use attachments recommended or sold by the manufacturer.

INSTALLATION & OPERATING INSTRUCTIONS

  1. Unpack unit. Save carton for off-season storage (if needed).
  2. The unit will turn on automatically when plugged in. For best catch results, leave the trap on and running, 24/7.
  3. Catch rate activity will be higher at night. For best catch results it is recommended to keep the unit away from competing for light sources.
  4. It is recommended to place the unit at least 20 to 40 feet away from where people will be sitting.
  5. This unit is all-weather resistant – designed for outdoor use including rainy conditions.
  6. The electrical adapter provided with this product is equipped with a 2-conductor cord and a 2-prong plug as a safety feature.
    If the plug does not fully fit in the outlet, contact a qualified electrician. To reduce the risk of electrical shock, only plug into a properly installed outlet. Do not attempt to defeat this safety feature.

FCC COMPLIANCE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or  television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following  measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

USER MAINTENANCE INSTRUCTIONS – CLEANING

Clean the trap at least once a week to prolong life of the unit, insure fire prevention, and provide for more efficient operation.

  1. Be sure to clean the unit once per week.

  2. Unplug before cleaning.

  3. For weekly cleaning, position the collection bag (not included) beneath the trap and press the top of the button on the basket. The bottom of the basket will open to release collected insects. Seal bag and dispose of in accordance with local regulations. Brush any remaining residue from the basket door and push up until you hear the button click closed, and secure.

  4. For major cleaning, twist the basket clockwise to remove it from the upper housing. After removing, use a soft brush and remove any dirt and debris from the fan housing.  Remove the damper assembly from the basket by grasping the crossbar and pulling it up firmly.
    Remove any buildup from the inside of the basket and damper with a brush and replace the damper by snapping firmly into place.

  5. When replacing the retaining cage – DO NOT press/push against the screen windows.

REPLACING BULB – Replace With DynaTrap UV-LIGHT LED Bulb #11020 (or equivalent G24-Q2 Type – DC 9V/1.8 W UVA Bulb) The UV-LIGHT LED light bulb life expectancy is approximately 20,000 hours (or about 2.25 years).

  1. UNPLUG UNIT, and allow the bulb to cool before replacing.
  2. Remove screw ( A ) undercover, twist counter-clockwise, and remove.
  3. Grasp lamp housing and twist to remove ( B ). Note: Lamp housing and lower sections will remain connected by electrical wire – Do Not Pull or Attempt To Disconnect.
  4. Cover the bulb ( C ) with a cloth to protect your fingers and hand. Grasp the bulb (with your hand and fingers protected by the cloth) and gently pull the bulb from the socket.
  5. Remove any debris from the lamp socket with a brush. Replace the new bulb by aligning the mark on the base of the bulb ( D ), with the corresponding mark on the socket ( E ) to assure proper alignment. Replace lamp housing and twist to secure ( C ).
  6. Replace cover and secure with screw ( A ).DYNATRAP DT162 Mosquito and Insect Trap with EZ Disposal Basket - figure 1

REPLACEMENT PARTS

11020 1, UV-LIGHT LED Replacement Bulb, G24-Q2 Type – DC 9V/1.8W
To see all replacement and accessory parts available for your DynaTrap, visit www.DynaTrap.com.

HOW THE DYNATRAP® INSECT TRAP WORKS

Flying insects are attracted to the unit by UV light and CO2 that is generated by the photo-catalysis between the UV-LIGHT LED lamp and special TiO2 coating. The fan then pulls the insects into the screened base, trapping them until they dehydrate and die. The base can be removed, allowing the contents to be periodically emptied into the trash. DYNATRAP DT162 Mosquito and Insect Trap
with EZ Disposal Basket - figure 2

TROUBLESHOOTING

Problem: Possible cause: Correction:
The bulb does not illuminate and the fan does not spin. No electrical power.

1. Check plug, receptacle, and fuse or circuit breaker.
Bulb illuminates, but the fan does not spin.| Shorted fan.| UNPLUG UNIT: Examine the fan to see that it is free from foreign material, dirt, or the buildup of dead insects. The clean unit is in the “CLEANING” section.
The fan spins, but the bulb does not illuminate.| 1. Bulb not seated properly
2. Burnt out bulb| 1. Check socket for proper bulb seating and alignment.
2. Replace bulb following instructions under “Replacing Bulb”

LIMITED WARRANTY

DYNAMIC guarantees to the original purchaser that this product is free from defective materials and workmanship. This warranty is limited to remedy any defective part for a  period of one year from the date of the original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply to the light bulb, nor to, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in force. This warranty does not apply if this unit is purchased outside the United States, excluding  Canada and Mexico. In no case shall DYNAMIC be liable for any accidental, punitive, consequential, or any other damages of any kind for breach of this or any other warranty,  expressed or implied, whatsoever. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation or exclusion may not apply to you. This  warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

SAVE THESE INSTRUCTIONS

Dynamic Solutions Worldwide, LLC
69 N. Locust St., Lititz, PA 17543
1-877-403-8727 (TRAP)
dynatrap@woodstream.freshdesk.com
www.DynaTrap.com

FOR HOUSEHOLD AND COMMERCIAL,
INDOOR AND OUTDOOR USE
100 – 240 V~ 50/60 Hz 0.06 A max.

This device complies with Performance Standards for Light-Emitting Products, 21 CFR, Part 1040, Chapter 1, Subchapter J, Radiological health.
A001-691.2021.4

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals