Honeywell TH5220D1029 FocusPRO Digital Thermostat User Guide
- June 7, 2024
- Honeywell
Table of Contents
Digital Thermostat
User GuideFocusPRO ® 5000 Series
View all Honeywell thermostat manual
This is a legacy product document supported by Resideo. It is no longer manufactured.
Read and save these instructions.
For help please visit yourhome.honeywell.com
Thermostat controls
Display screen
Auto changeover (heat/cool)
Auto Changeover is a feature used in climates where both air conditioning and
heating are used on the same day. When the system is set to Auto, the
thermostat automatically selects heating or cooling depending on the indoor
temperature.
Heat and cool settings must be at least 3 degrees apart. The thermostat will
automatically adjust settings to maintain this 3-degree separation (called
“Deadband”).
The 3-degree separation between heating and cooling set temperatures is fixed,
and cannot be changed.
- Press the system button until the screen displays “Auto”.
NOTE: The Auto system setting may not appear, depending on how your thermostat was installed.
Built-in compressor protection
Damage can occur if the compressor is restarted too soon after shutdown. This
feature forces the compressor to wait for a few minutes before restarting.
During the wait time, the display will flash the message Cool On (or Heat On
if you have a heat pump). When the safe wait time has elapsed, the message
stops flashing and the compressor turns on.
Battery replacement
Batteries are optional (for backup power) if your thermostat was wired to run
on AC power when installed.
Install fresh batteries when the REPLACE BATTERY warning begins flashing. The
warning flashes about two months before the batteries are depleted.
Replace batteries once a year, or before leaving home for more than a month.
All settings are permanently stored in memory and do not require battery
power.
Customer assistance
For assistance with this product, please visit
yourhome.honeywell.com.
Or call Honeywell Customer Care toll-free at
1-800-468-1502.
CAUTION
Equipment damage hazard
To prevent possible compressor damage, do not operate the cooling system when
the outdoor temperature is below 50°F (10°C).
Accessories/replacement parts
To order, please call Honeywell Customer Care toll-free at
1-800-468-1502.
TH5110D
Battery holder ………………………Part No. 50000951-001
Cover plate assembly …………..Part No. 50001137-001
Cover plate assembly …………..Part No. 50002883-001
TH5320U/TH5220D
Battery holder ………………………Part No. 50007072-001
Cover plate assembly …………..Part No. 50002883-001
Use to cover marks left by old thermostats.
Troubleshooting
If you have difficulty with your thermostat, please try the following suggestions. Most problems can be corrected quickly and easily.
Display is blank
- Check the circuit breaker and reset if necessary.
- Make sure the power switch at the heating & cooling system is on.
- Make sure the furnace door is closed securely.
- make sure fresh AA or AAA alkaline batteries (depending on model) are correctly installed (see page 3).
The heating or cooling system does not respond
- Press the SYSTEM button to set system Heat (see page 2). Make sure the temperature is set higher than the Inside temperature.
- Press the SYSTEM button to set the system to Cool (see page 2). Make sure the temperature is set lower than the Inside temperature.
- Check the circuit breaker and reset if necessary.
- Make sure the power switch at the heating & cooling system is on.
- Make sure the furnace door is closed securely.
- Wait 5 minutes for the system to respond.
Temperature settings do not change
Make sure heating and cooling temperatures are set to acceptable ranges:
- Heat: 40° to 90°F (4.5° to 32°C).
- Cool: 50° to 99°F (10° to 37°C).
“Cool On” or “Heat On” is flashing
- The compressor protection feature is engaged. Wait 5 minutes for the system to restart safely, without damage to the compressor (see page 3).
5-year limited warranty
Honeywell warrants this product, excluding battery, to be free from defects in
the workmanship or materials, under normal use and service, for a period of
five (5) years from the date of purchase by the consumer. If at any time
during the warranty period the product is determined to be defective or
malfunctions, Honeywell shall repair or replace it (at Honeywell’s option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the
place from which you purchased it; or
(ii) call Honeywell Customer Care at
1-800-468-1502. Customer Care will make
the determination whether the product should be returned to the following
address:
Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr. N., Golden Valley,
MN 55422, or whether a replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty
shall not apply if it is shown by Honeywell that the defect or malfunction was
caused by damage that occurred while the product was in the possession of a
consumer.
Honeywell’s sole responsibility shall be to repair or replace the product
within the terms stated above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR
DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS
OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so this
limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS PRODUCT.
THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE
FIVE-YEAR DURATION OF THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so
the above limitation may not apply to you. This warranty gives you specific
legal rights, and you may have other rights which vary from state to state.
If you have any questions concerning this warranty, please write Honeywell
Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call
1-800-468-1502. In Canada, write Retail
Products ON15-02H, Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive,
Toronto, Ontario M1V4Z9.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
yourhome.honeywell.com
® U.S. Registered Trademark.
© 2013 Honeywell International Inc.
69-1923EFS—03 M.S. Rev. 07-13
Printed in the U.S.A.
https://thermostat.guide/honeywell/honeywell-th5220d1029-focuspro-digital- thermostat-user-guide/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>