COBY CETW536 True Wireless Stereo Earbuds User Manual

June 1, 2024
COBY

COBY CETW536 True Wireless Stereo Earbuds

Box Content

Box Content
Box Content

Overview

CETW536 True Wireless Stereo Earbuds

Overview

Charging case for the CETW536

Overview

Charging

Charging

Charging Flashing red (Case power indicator)
Fully charged ● Steady red (Case power indicator)

Notes: To check the charging case’s remaining battery power, take out the earbuds from the charging base and then place them back. If there is remaining battery power, the case power indicator will glow white. If the case battery power level 1s low, it will flash white.

Charging your earbuds

When your earbuds’ battery runs low, the earbud status indicators will slowly flash red, and a notification tone will play. Open the charging case’s lid, then place the earbuds into the charging case and close the lid to start recharging.

Charging your earbuds

Charging ● Steady red (Earbud status indicator)
Fully charged OFF (Earbud status indicator)

Powering on/off

Powering on
Your CETW536 earbuds will power on automatically when taken out of the charging case. You can also power them on manually by pressing and holding the Touch Sensor on both earbuds for 7 seconds.
Powering on/off

ON

| Alternating Flashing red and white on both earbuds
---|---
Power on tone notification

Powering off

Your CETW536 earbuds will power off automatically when placed back into the charging case.

Powering off

To power them off manually, press and hold the Touch Sensor on a single earbud for 7 seconds.

Off

| Flashing red 3 times
---|---
Power off tone notification

Pairing

  1. True Wireless stereo connection
    When the earbuds are turned on, they will automatically enter True Wireless stereo pairing mode.
    PairingEnter True Wireless stereo pairing mode| Alternating flashing red and white on both earbuds
    ---|---
    When True Wireless Stereo connection is flash successful (the right and left earbuds are connected)| Alternating flashing red and white on the left earbud, flashing white on the right earbud.
    Connected tone notification
  2. Bluetooth connection with your device
    After a successful True Wireless stereo connection, your
    CETW536 earbuds will automatically enter Bluetooth pairing mode to connect to your device.
    Turn on Bluetooth in your device’s settings and search for “CETW536”, then tap “CETW536” to connect.
    Pairing

Pairing mode| Alternating flashing red and white on the left earbud, flashing white on the right earbud.
---|---
Connected to a device (Successfully paired)| OFF LED lights on both earbuds are off
Connected tone notification

The earbuds will automatically be paired with your last successfully connected media device the next time they are turned on.

Controls

Music mode

Play/Pause Press the Touch Sensor once on either
Next track Quickly press the Touch Sensor twice on the right earbud
Previous track Quickly press the Touch Sensor twice on the left earbud
Volume up Quickly press the Touch Sensor three times on the right earbud
Volume down Quickly press the Touch Sensor three times on the left earbud

Phone call mode

Answer /End a call Quickly press the Touch Sensor twice on either earbud
Reject a call Press and hold the Touch Sensor for 1 second on either earbud

Voice Assistant mode

Activate voice assistant| Press and hold the Touch Sensor for 2 seconds on either earbud
---|---
Exit vo ice assistant| Press the Touch Sensor on either

Troubleshooting

Problem Solution

Your left and right earbuds aren’t connected. The LED indicators on both earbuds are alternat­ing between red and blue lights.| First, reset the earbuds by taking out the earbuds from the charging base and then placing them back to check wheth­er they are connected to each other. If they are not, open Bluetooth settings in your device and tap “Forget device” on “CETW536”, then turn off Bluetooth in your device to manually initiate the True Wire stereo connection. Please allow up to 30 seconds to connect if you are in a public area with interfering signals.
Your left and right earbuds are connect­ ed, but you cannot connect them to your device (phone, laptop, tablet, etc.)| Ensure the earbuds are not currently connected to another device. If they are, open Bluetooth settings on those devices and tap “Forget device” on “CETW536” Confirm the device you would like to pair with is Bluetooth enabled, please refer to that device’s user manual to confirm.
There is no response from the CETW536 earbuds.| Firstly, check whether the battery pow­ erin earbuds are used up, if they are, charge the earbuds. If they are not, reset the earbuds by taking out the earbuds from the charging base and then placing them back.
You can only hear sound on one earbud.| Reset the earbuds by taking out the earbuds from the charging base and then placing them back.

Specifications

Model No./ Name CETW536/TWS Earbuds
Power Input 5 V/ 0.2A (Earbuds)

5 V/1 A (Charging Case)
Charging time (Earbuds)| 1 hour
Charging time (Charging case)| 1 hour
Playtime (Earbuds)| Up to 3 hours
Playtime (With charging case)| Up to 12 hours
Battery Type| Rechargeable Lithium -ion
Driver (full range)| 10 mm x 2
Range| 33ft (10 m)
Bluetooth version| V 5.3
Dimension (Earbud)| 20 x 16 .5 x 13 mm
0.79 x 0.65 x 0.51 inch
Dimension (Charging case)| 35 x 35 x 28.5 mm
1.38 x 1.38 x 1.12 inch
Weight (earbuds alone)| 0.198 oz / 5.6 g
Weight (wit h charging case)| 0.80 oz / 22.7 g

Specifications are subject to change without notice.

FCC Statement

FCC ID: 2AMSOE1W002

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) consult the dealer or an experienced radio / TV technician for help.

Notice

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling.
Follow local rules and never dispose of the product and rechargeable
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.

Disclaimer
All information, design and specifications contained in this manual were correct at the time of this publication. As the product goes under continuous upgrades and changes, however, the flan device may have slight

COBY COPYRIGHT© 2023 ALL RIGHTS RESERVED. COBY IS A REGISTERED TRADEMARK OF CBY HOLDINGS, LLC. MANUFACTURED BY SUMMIT ELECTRONICS LLC. USED UNDER LICENSE. CBY HOLDINGS, LLC DDES NOT MANUFACTURE THIS PRODUCT OR PROVIDE ANY MANUFACTURER’S WARRANTY OR SUPPORT. THE BLUETOOTH® WORD MARK AND LOGOS ARE REGISTERED TRADEMARKS OWNED BY THE BLUETOOTH SIG, INC. AND ANY USE OF SUCH MARKS BY SUMMIT ELECTRONICS LLC IS UNDER LICENSE. OTHER TRADEMARKS AND TRADE NAMES ARE PROPERTY OF THEIR RESPECTIVE OWNERS.

WARNING: CANCER AND REPRODUCTIVE HARM – WWW.P65WARNINGS.CA.GOV.

SUMMIT ELECTRONICS LLC One Year Limited Warranty

Categories Listed in Chart Below (as applicable, M Product”) Before returning your Product for service under this Warranty, please 0) read the instruction manual carefully. If you are still having trouble with your Product, please contact Technical Support at support@summitcegroup.com.

Warning: Some Products may contain components that are small enough to be swallowed. Please keep out of reach of children.

Subject to the terms and conditions herein, SUMMIT ELECTRONICS LLC (hereinafter called “SUMMIT ELECTRONICS LLC”) warrants to the original purchaser of the Product (•customer”) that for the applicable Warranty Period listed below, the Product will be free from defects in material or workmanship under normal, non-commercial use (“Defects•).

Warranty Period encompasses, as listed below, separate ”coverage Periodsn for Parts and Labor, each Coverage Period for one year, to begin from the original date of Customer purchase. If Customer returns a defective Product (or any component thereof) during the applicable Warranty Period, SUMMIT ELECTRONICS LLC will, at its option, dur ing the specified Coverage Periods for Parts and Labor (as applicable) either: (Q repair the Product (or, as applicable, any component thereof) or (ii) replace the Product (or, as applicable, any component thereof) with a new or refurbished Product (or, as applicable, any component thereof), in either case free of charge to Customer for Parts and/ or Labor (as applicable) during the specified coverage Period only, and excluding applicable shipping charges (noted below), for which the Customer is responsible.
The foregoing states the Customer’s exclusive remedy and SUMMIT ELECTRONICS LLC’s sole liability for breach of the limited warranty contained herein. This Warranty specifically excludes any Product (or, as applicable, any component thereof) that has been subject to or Defects resulting from: (a) any neglect or misuse by a Customer, an accident, improper application, violation of operating instructions for the product, any other Customer-induced damage, or the alteration or removal of any product serial number. (b) any modification or repair to Product (or, as applicable, any component thereof) by any party other than SUMMIT ELECTRONICS LLC or a party authorized in writing by SUMMIT ELECTRONICS LLC; (c) any damage to Product (or, as applicable, any component thereof) due to power surges, incorrect electrical voltage, misconnection 17 to any device, or malfunction of any device used with the Product (or, as applicable, any component thereof); (d) cosmetic damage to the Product (or, as applicable, any component thereof) caused by normal wear and tear; (e) shipping damage that occurs while the Product is in transit; (f) damage caused by heat sources, sunlight, electromagnetic conditions, or other climatic conditions; or (g) any acts of God. Product is sold to Customer for personal, non-commercial use only. Product is not warranted for Customer’s commercial or rental use. In addition, Product is not warranted against failure, and should not be used by Customer for any application where (0 there is a risk that any data stored on Product will be breached or otherwise compromised, or Oi) the data stored on Product is relied upon for medical or lifesaving applications. SUMMIT ELECTRONICS LLC disclaims any Warranty for any of the foregoing uses to the fullest extent permitted by law. Customer assumes any and all risks associated with such uses of Product and agrees to indemnify SUMMIT ELECTRONICS LLC for any damages claimed against SUMMIT ELECTRONICS LLC for such uses.
EXCEPT FOR EXPRESS WARRANTIES STATED ABOVE AND TO THE MAXIMUM EXTENTPERMITTED BYLAW, THE PRODUCTS ARE PROVIDED “AS IS”, AND SUMMIT ELECTRONICS LLC DISCLAIMS ALLOTHER WARRANTIES, INCWDING WITHOUT LIMITATION ANY IMPLIED WARRANTY(!} OF MERCHANTABILITY, (II) OF FITNESS FOR APARTICULAR PURPOSE, OR (Ill} OF NON- INFRINGEMENT OF THIRD-PARTY RIGHTS. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT WILL SUMMIT ELECTRO- NICS LLC BE LIABLE TO CUSTOMER OR ANY THIRD PARTY FOR ANY INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY OR PUNITIVE DAMAGES, INCLUDING, WITHOUT LIMITATION, ANY LOST PROFITS OR REVENUES, LOSS OR INACCURACY OF ANY DATA OR COST OF SUBSTITUTE GOODS, REGARDLESS OF THE THEORY OF LIABILITY (INCLUDING NEGLIGENCE) AND EVEN IF SUMMIT ELECTRONICS LLC HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, SUMMIT ELECTRONICS LLC’S AGGREGATE LIABILITY TO CUSTOMER FOR ACTUAL DIRECT DAMAGES FOR ANY CAUSE WHATSOEVER SHALL BE LIMITED TO THE CUMULATIVE PRODUCT FEES PAID BY THAT CUSTOMER FOR THE PRODUCT CAUSING THE DAMAGES, IF ANY.
This Warranty gives Customer specifics rights, and Customer may also have other rights that vary from jurisdiction to jurisdiction. To obtain Warranty service, Customer must email SUMMIT ELECTRONICS LLC Technical Support prior to making a Product return. Customer must include with Product return the following items (failure to enclose any of these items may result in a delay in the processing of your Warranty claim): (i) a dated sales receipt that indicates the place of purchase, model number of Product, and amount paid; (ii) a detailed description of Customer’s problem with Product; (liQ Customer’s full name, phone number, and return address, and; (Iv) a money order made out to SUMMIT ELECTRONICS LLC Electronics Corporation to cover return shipping charges to US destinations only, for the applicable dollar amount shown for the Product in the table above. SUMMIT ELECTRONICS LLC will not make return shipments to a P.O. Box. For shipping to international addresses, actual freight will be charged to Customer. Return your Product freight-prepaid in its original packaging, or packaging that affords an equal measure of protection. Please allow 4 to 6 weeks for the processing of your claim (6 to 8 weeks from November to February).

Product Category Shipping
Adapters, Converters, Chargers, Headphones, Microphones, Cellular Accessories

$7.99
Alarm Clocks, Portable CD Players, Radios, Corded Telephones, MP3 Players, Digital Photo Frames (screen size less than 5″)| $7.99
Portable Stereo Systems, Speaker Systems, Cordless Telephones, Home DVD Players| $14 .99
Home Theater DVD Systems, Portable DVD Players, Portable Media Players, Digital Photo Frames (screen sizes 5″ to 11″)| $14.99

You must email SUMMIT ELECTRONICS LLC Technical Support prior to making a return .Please ask if you are unsure of which category your product falls under.
*US destinations only.

Icon Customer Service

To get the best after-sales service, access the
Contact webpage from the link:
https://summitcegroup.com/pages/contact.
Or email us at support@summitcegroup.com
for return information and customer support!

For more information please visit:
https://summitcegroup.com

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals