VonHaus 3500215 6.5m UK Plug to Type 2 10A Car Charging Cable Instruction Manual
- June 5, 2024
- vonhaus
Table of Contents
VonHaus 3500215 6.5m UK Plug to Type 2 10A Car Charging Cable
Instructions
Please read all instructions carefully before use and retain for future reference.
INTENDED USE
Only operate the product for its intended purpose and within the parameters
specified in this manual. This product is for domestic use only. Ensure the
product rating matches the power outlet. Use with RCD protected power supply
only. Only use for charging compatible electric vehicles. This product is not
intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless supervised or given
appropriate instruction concerning the product’s use by a person responsible
for their safety. Never use a domestic multi-socket extension lead when
charging your electric vehicle unless otherwise stated by the car manufacturer
charging instructions.
ALWAYS use this product in conjunction with Vehicle charging
instructions. Ensure you frequently check your charging cable for wear and
tear and replace it if any damage is evident. Do not use if any part of the
equipment is damaged. If you are charging from a 13A mains socket in your
home, ensure the wiring in your property has been checked prior to doing so.
Old wiring may not be able to cope with the demand from charging your vehicle
overnight and risk a fire in your property. Before using the charger, read all
instructions, labels and cautionary markings on the charger. DANGER Do not
use the charger if it has been subject-ed to a heavy knock, dropped, or
otherwise damaged in any way. Take the charger to an authorised service centre
for it to be checked and repaired.
DANGER Risk of Electrical shock or burn. The device contains no user
serviceable parts. Please do not leave until the control box is in charging
status. Do not attempt to disassemble the charger by opening or removing
covers. To reduce risk of damage to the electric plug and cord, pull by the
plug rather than the cord when disconnecting the charger. Do not drop the
communications box. Do not place the charger inside the vehicle or any other
confined space whilst charging. A Short-circuit protective device (MCB) should
be used before the Charger input.
GENERAL PRECAUTION
If the product is not functioning properly, has been dropped, damaged, left outdoors, or immersed in liquid, do not use, contact DOMU Brands Customer Services. Do not use the product if any parts appear to be faulty, missing or damaged. Ensure all parts are securely attached before use. Never soak or immerse electrical components and or a component that has a plug attached. Make sure that the cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. Remove the plug from the mains socket before carrying out any adjustment or maintenance. Always store the product in a dry place. If the power cord is damaged, it must be replaced by a qualified service technician. Clean the product by rubbing it with a clean cloth and blow it clean using low-pressure compressed air is recommended. Ensure you have all the pieces listed. If you are missing any components, contact our customer services department at support@domu.co.uk DO NOT proceed with assembly if any components are missing.
TECHNICAL SPECIFICATION
- Input: 110V-250V 10A
- Charging Output: 110V – 250V 10A Ingress protection Rating: IP54
- Rated Current: 10A
- Rated Voltage: 110-250V 10A
- Resitance Voltage: 2000V
- Insulation Resitance: >1000M
- Contact Resitance Less than 0.5m Insertion and Extraction force 80N<F<100N Fire Rating: UL984 V-0
- Operating Tempreture: -30 to 50°C
- Cable Specification: 3 x 2.5mm2 / 6mm2
COMPONENTS
Type 2 connection is widely used for European vehicles. It has a round housing, which is flattened on one side for correct orientation. It uses a seven-pin-and-sleeve contact for up to four AC conductors. A protective conductor and two signal pins are used for the control pilot function (according to IEC 61851-1 Annex A) and for simultaneous proximity detection and current coding (according to IEC 61851-1 Annex B. When connected, it is held into place by the locking mechanism, which is attached to the unit. The same concept is used by the socket-outlet to hold the plug in place.
OPERATION
To begin charging
- Take the charging cable and insert the plug into a suitable power supply outlet.
- Remove the protective cap and fully insert the charging connector into the charging port ensuring the connector is secure.
- The charger will automatcaily begin charging the red LED will be illumanted and the green LED will flash.
NOTE: If charging does not begin automatically and the LED sequence is not as indicated as above refer to the Staus LED Meaning.
To end charging
- Disconnect the plug from the power supply outlet.
- Disconnect the charging connector from the vehicle.
- Close the proctecvtive cover on the vheicle, and place the protective cap onto the charging connector.
STATUS LED MEANING
DISPOSAL INFORMATION
Please recycle where facilities exist. Check with your local authority for recycling advice.
CUSTOMER SERVICE
If you are having difficulty using this product and require support, please contact support@domu.co.uk
WARRANTY
To register your product and find out if you qualify for a free extended warranty please go to www.vonhaus.com/warranty. Please retain a proof of purchase receipt or statement as proof of the purchase date. The warranty only applies if the product is used solely in the manner indicated in the warnings page of this manual, and all other instructions have been followed accurately. Any abuse of the product or the manner in which it is used will invalidate the warranty. Returned goods will not be accepted unless re-packaged in its original packaging and accompanied by a relevant and completed returns form. This does not affect your statutory rights. No rights are given under this warranty to a person acquiring the appliance second-hand or for commercial or communal use. COPYRIGHT All material in this instruction manual are copyrighted by DOMU Brands. Any unauthorized use may violate worldwide copyright, trademark, and other laws.
THANK YOU
Thank you for purchasing your product /appliance. Should you require further
assistance with your pur-chase, you can contact us at support@domu.co.uk
VonHaus is a registered trademark of DOMU Brands Ltd.
Made in China for DOMU Brands. M24 2RW.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>