MoKitDora Dyna Softail Touring Easy Lever Pull Ramp Reduced Effort Clutch Kit Installation Guide
- June 1, 2024
- MoKitDora
Table of Contents
MoKitDora Dyna Softail Touring Easy Lever Pull Ramp Reduced Effort Clutch
Kit
INSTALLATION INSTRUCTIONS
Caution:
- The installation should be performed by an authorized dealership or repair shop!
- We do not take over any liability for inappropriate installation/craftsmanship!
-
Jack up the motorcycle with an appropriate tool (motorcycle jack/lift) and ensure a safe stand.
-
Open the lock nut on the clutch control cable and relax it.
-
Remove the clutch adjustment service cover with an appropriate tool.
-
Remove the lock nut (including the spring), then turn the adjustment screw with a screwdriver clockwise inwards to allow the removal of the original lock nut from the clutch segment.
-
Separate the clutch segment from the clutch control cable. Connect the new Mueller segment with the clutch cable and insert it into the cover.
-
Reinstall the clutch lock nut by counter-turning it against the adjustment screw.
-
Adjust basic clutch settings according to manu-facturer speci□cations. Turn the adjustment screw to the left until you feel a noticeable resistance, and work the clutch lever 1-2 times while you do that. Repeat this procedure twice to give the parts a chance to adapt to the new clutch segment. After that loosen the adjustment screw 1/8 instead of the orig. recommended 1/4.
IMPORTANT: The clutch segment may not be under any tension! -
Insert the clutch lock nut and spring, and reinstall the clutch cover.
-
Adjust the clutch cable by turning the adjustment screw so far outward to allow 2-3 mm travel for the clutch lever.
WARNING: Counter Secure All Connections! -
Go for a test ride and check the clutch thoroughly.
Note:
Do not use leather decoration on the clutch lever – they could restrict the
lever actions and the clutch won’t displace accurately, shifting may be
harder.
Caution:
You should not use After Market clutch cables or lever blades. Perfect
operation of the clutch is only given when using original H-D® parts.