JINGDA Smart App Remote Control Bulb Instruction Manual
- June 5, 2024
- JINGDA
Table of Contents
JINGDA Smart App Remote Control Bulb
SPECIFICATION
- Nominal power: 9W
- Nominal Lumen: 900LM
- Working voltage: AC85-265V
- Lamp size: φ6CM*12CM
- Lamp material: plastic-coated aluminum
- Remote control size: width 4cm height 15.2cm thickness 1.5cm
- Remote control built-in battery: 2 AA batteries 2*1.5V=3V
Instructions for use
Remark:
- Please download the correct version of the mobile APP
Remark:
- Details of APP usage instructions
Remark:
- Different rooms can be added, and different lamps can be added in the room, which can be controlled uniformly or individually.
- The master control can control all rooms.
Remark:
- Before pairing lamps, after adding rooms, enter the link of adding lamps.
- Press the pairing button within 5 seconds after turning on the light to pair.
- When pairing, the light flashes, indicating that the pairing is successful, if not, please turn off the light and turn it on again, and press the pairing button within 5 seconds to pair.
Remark:
- The remote control uses 2 AA batteries
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment The devices has been evaluated to meet general RF exposure requirements, The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>