Skullcandy S2GTW-P749 Grind True Auriculares Inalambricos User Manual
- June 5, 2024
- Skullcandy
Table of Contents
Skullcandy S2GTW-P749 Grind True Auriculares Inalambricos
INSTRUCTIONS
- Place the earbuds in the Charging case and leave the lid open. The LEDs will illuminate.
- Open Bluetooth settings on your device. Select Grind from the list of available devices.
- Accept any PAIR or OK prompts. Your earbuds will connect to your device. They are now ready to use.
Controls
Tip: Download the Skullcandy App for easy, always-on access to this list and additional features.
Button Control
Power On / Off:
Remove the earbuds from the case to power ON and connect. Place the earbuds in
the case and close the lid to power the earbuds OFF and charge.
Voice Control
Hey Skullcandy:
With the Skullcandy App, you can enjoy hands-free control of your favorite
media player and other functions using just your voice
Press 1 Time
- Play/Pause: Either Earbud
- Answer/End Call: Either Earbud
Press 2 Times
- Volume Up: Right Earbud
- Volume Down: Left Earbud
Press and Hold
- To Launch and Play Spotify
- 1 Second: Play Audio: Left Earbud
- Share Audio Botwoen Two Skullcandy Skull–Q Enabled Products
- 3 Seconds: Share Audio: Right Earbud
- 3 Seconds: Join Audio: Leit Earbud
Press Once, Release Press Again & Hold
- 1Second: Pair New Device: Ether Earbud
Spotify / Media Player Commands
- “Hey “Hey Skullcandy, Play”
- “Hey Skullcandy, Pause”
- “Hey Skullcandy, Next”
- “Hey Skullcandy, Previous”
- “Hey Skullcandy, Volume Up”
- “Hey Skullcandy, Volume Down”
Call Mode Commands
- “Accept”
- “Reject”
Having trouble?
No audio in one earbud?
Let’s re-sync your earbuds. Place them In the charging case and close the lid
for 2 seconds. When removed, both earbuds should play audio. If not, return
the earbuds to the case and follow the steps below.
- On your device, open Bluetooth settings and turn Bluetooth OFF.
- Remove both earbuds irom the charging case. Make sure they are both powered ON.
- Press the button on both earbuds 3times simultaneously. The LED will go through a series of pulses as they re-sync. 5 blue flashes indicate a successful sync.
- On your device, open Bluetooth settings and tum Bluetooth ON and select “Grind
- LEDs in both earbuds will blink blue 3 times. A voice prompt will Indicate when the earbuds are connected.
Resetting your earbuds to resolve pairing issues.
- On your device, open your Bluetooth settings and remove “Grind” from your paired devices List. Then turn Bluetooth OFF.
- Remove both earbuds from the case. A voice prompt will indicate that your earbuds are powered ON.
- Press and hold the button simultaneously on both earbuds for 3 seconds.
- Both earbuds will flash purple 3 times. A tone will indicate a successful reset.
- On your device, open Bluetooth settings and turn Bluetooth ON. Select “Grind” and accept any PAIR or OK prompts to complete pairing.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>