TRYHRD ONI S WIRELESS Rechargeable Gaming Mouse User Manual

TRYHRD ONI S WIRELESS Rechargeable Gaming Mouse

Function layout

❶ Left click
❷ Right click
❸ Middle click
❹ Forward
❺ Backward
❻ DPI
❼ Scroll up
❽ Scroll down
❾ Polling rate:125Hz
❿ Polling rate:500Hz
⓫ Polling rate:1000Hz
⓬ RGB On
⓭ RGB Off
⓮ Power Off
⓯ USB-C Connection

Instruction

Mouse instruction:

1. Remove the USB nano receiver located inside the Oni S Wireless.
2. Plug the nano receiver into your PC’s USB port.
3. Turn on the power switch located on the bottom of the mouse.
4. Allow for the installation to finish.

DPI setting and indication

1. DPI levels: 400-800-1600-2400-3200-6400.
2. To scroll through the DPI levels, press the DPI button on the top of the mouse.
3. The scroll wheel LED color indicates the DPI levels in the sequence below:
   400 DPI: Red. 800 DPI (default): Blue. 1600 DPI: Green.
   2400 DPI: Yellow. 3200 DPI: Cyan. 6400 DPI: Purple.

Note:

1. The DPI levels can be configured with our software. The default polling rate is 1000 Hz.
2. The DPI LED effects can be configured with our software.

Polling rate:
The polling rate is set by default: 125-500-1000 Hz. The bottom switch allows you to toggle it.

Power switch function

1. “RGB off” switch position: turns on the mouse, but does not activate the RGB LED.
2. “Power off” switch position: turns off the mouse.
3. “RGB on” switch position: turns on the mouse and RGB LED.

Wired and wireless function

1. The Oni S Wireless automatically switches between wired and wireless mode even with the USB nano receiver plugged in the PC.
2. The Oni S Wireless will automatically switch to wired mode when the USB-C cable is plugged into the mouse.

Low power and charging indication

1. Low power indication: when the battery power is low (< 3.5V), the Oni S Wireless will flash red.
2. When the Oni S Wireless is charging, it will flash yellow. Once it is fully charged, it will flash green and stop charging automatically.

Pairing

1. Use the pairing software to pair the USB nano receiver and the Oni S Wireless if you replace your receiver or the connection cannot be established.

*Note: If you wish to customize the Oni S Wireless further, please download  oursoftware at www.tryhrd.shop.

CAUTION

1. Keep the battery in a dry environment. .
2. Avoid contact with the battery terminal and metallic objects.
3. Do not short-circuit the mouse and avoid metallic objects or water.
4. Charge your mouse ONLY with a computer and our USB-C cable.

Main Specification

400-800-1600-2400-3200-6400DPI
IPS| 400ips
Acceleration| 50g(Max)
LOD| 1mm and 2mm
Polling rate| 125-500-1000Hz
Interface| USB 2.0
Battery type| Li-ion Polymer Battery
Battery capacity| 500mAh
Charging time| Around 2.5h

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>