PHILIPS CorePro LED HPI Lamps Installation Guide

Installation Guide
– Philips CorePro LED HPI lamps

CorePro LED HPI Lamps

Please take the time to read this installation guide. The guide contains important information and notes regarding the installation and operation.

IMPORTANT!

• Always switch off the power supply before commencing work!
• The LED lamp is suitable for direct main voltage input.
• The LED lamp is NOT compatible with dimmers.
• The LED lamp is NOT compatible to use with ballast.
• Suitable for use in operating temperature range between -20C to +45°C.
• If an LED lamp is being used within the luminaire, the minimum dimensions requirement on the lamp compartment is (Hx0) 400mmx3 I 0mm. if the luminaire comes with a glass/cover, it’s recommended to detach it for optimal light efficiency and product lifetime. Please check the Tc temperature in the application guide for the best performance.
• Do not change the structure or any components of the LED lamp to ensure safety.
• The LED lamp is designed to fit in standard IEC compliant E40 lamp holders.
• The LED lamp should be installed by a qualified professional electrician.
• Perform inspection before installation to ensure the luminaire/lamp holder is in good condition to carry the weight and performance of the LED lamp.
• The LED lamps should be positioned so that prolonged staring into the luminaire at a distance closer than I’m is not expected.
• The LED lamp fulfilled the IP20 requirement.
• The LED lamp is designed for general lighting service.
• Please do not apply the LED lamp in applications that contain emergency or/and explosive-proof luminaires.
• The total system performance may vary depending on the lighting/luminaire system.
• For the latest information, please refer to www.philips.com/lighting
• In case of doubt, please consult Signify representative.

For replacing MH HID lamp, convert to mains voltage input

Perform a visual inspection to ensure the lamp holder and internal wiring are not damaged, if the lamp holder is damaged, corroded, charred, blackened, or loose, the lamp holder should be replaced with a new lamp holder. if the internal wire is damaged, it should be replaced with a new wire.

1. Switch off the power to the luminaire.
2. Remove the diffuser/glass (if provided} and the existing lamp from the luminaire.
3. Bypass the gear including ballast/capacitor/ignitor and connect lamp-holder wires directly to AC supply leads. Use only on I I 0-240VAC, 50/60 Hz circuits.
4. Check the socket condition (replace it if the condition is poor) then screw in the Philips True Force LED lamp into the E40 lamp holder firmly.
5. Affix the sticker provided inside the luminaire where it is prominently visible to future installers. The sticker serves to notify that the luminaire has been modified and does not accept traditional HID lamps any longer.
6. Switch on power.

| Lamp not suitable for EM ballast operation
---|---
| Dimming not allowed
| Lamp not suitable for use under dust and moisture
****| This product should not be disposed of with other household wastes throughout the EU

02022 Signify Molding
@ignify

All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable, and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use. Publication thereof does not convey nor imply any license under patent or other industrial or intellectual property rights. Philips and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V. and are used under license 05/2022
3241 659 77271
www.philips.com/lighting

DISCLAIMER:
Signify disclaims liability for any direct, indirect, or incidental damages in case of installation performed either not according to this guide or not performed by a professional electrician.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>