Amico B0957B5R26 4 Slam Downlight Instruction Manual

Amico B0957B5R26 4 Slam Downlight Instruction Manual

HOW TO INSTALL

1. Install the drywall directly over the rough-in paper.
   NOTE: It is suggested to use your own method in locating the center of the aperture hole.

2. Select your desired method of cutting either using a hand saw or hole saw to cut an opening in the ceiling by using the provided template.

3. After selecting the desired method of cutting, cut out a 4.33” diameter hole in the mounting surface.
   CAUTION:
   Do NOT cut a hole that exceeds or that is larger than the paper opening.

4. Make sure all POWER IS TURNED OFF at the electrical source to the location in which you are mounting the luminaire.

5. Remove the cover of the provided J-BOX and insert wire nuts to make connections with power supply. Insert splices in J-BOX before concealing the cover.
   

6. Connect the J-BOX to the light module.

7. Turn on the power and slide the CCT Selection Switch to test the light.
   
   BEFORE INSTALLATION:
   On the back of the J-BOX, slide the CCT Selection Switch and choose from five available color temperatures: 2,700K; 3,000K; 4,000K; 5,000K; and 6,000K.

   • Test results from each CCT Selection to determine which brightness level suits your room best.
   • The light will use the preferred setting whenever you turn on the switch.
   • Turn off the light switch and continue with the installation.

8. Place the J-BOX through the cut-out hole and mount according to your local electrical code compliance.

9. Rotate and hold both spring clips upward to allow passage through the cut-out in the ceiling.
   Continue to press the light module through the cut-out hole until it is securely fixed and flushed with the ceiling.
   

Spring replacement installation

If a spring is found to be damaged, remove the spare spring from the fitting bag and replace it as follows:

• Pull out the buckle circled in red in Step 1 and place it in the position shown in Step 2.

• Place the parts circled in red as shown in the picture.
  

• Put the buckle back into the spring ring.

• Press the tilted side of Step 3 inward to the position of the red circle in Step 4.
  
  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>