Luceco T8 LED Eco Climate Installation Guide
- June 5, 2024
- LUCECO
Table of Contents
Luceco T8 LED Eco Climate
ASSEMBLY AND INSTALLATION
ACCESSORIES:
This luminaire is made from polycarbonate with polycarbonate clips. Ensure product is suitable for installation area. This Luminaire is suitable for use in temperature of 10°C to +40°C. Surface mounted only. Disconnect the power supply before installation.
- Fix plastic retainer clips to bottom fitting housing.
- Remove gear tray by rotating holders or releasing fixing clips. Lift to remove.
- Fix lamp holders from the rear of the gear tray (the two wired to the terminal block and the two included in the acessories pack to be installed at opposite ends.)
- Drill the fixing holes at suitable place for installation lwall/ceiling) fix the body to the fixing clips.
- Fit cable gland and suitable cable through gland entry at end of the base. Ensure hole is removed of burrs to ensure IP65 seal.
- Connect to 3way terminal block on the underside of the gear tray, ensure correct polarity.
- Refit gear tray, and ensure secure, refit T8 LED tubes and rotate. Note ensure powered end of tube, is inserted into correct end, with powered lamp holders.
- Refit diffuser and secure all clips.
- Re-initiate power and operate as required.
ADDITIONAL INFORMATION COMPONENT REPLACEMENT
This product is fitted with single ended Luceco LED T8 tubes. When replacing tubes, ensure they are replaced with Luceco LED T8 tubes.
United Kingdom Warranty
For other territories and for further information, please see www.luceco.uk for details Products are protected for a period of 2 years warranty from date of purchase against defects in material and workmanship lunless otherwise stated). Should a product fail to perform as described within the warranty period it will be repaired or replaced with the same or equivalent product by Luceco, free of charge provided that you: (1) return the product to us with shipping charge prepaid, (2) provide us with proof of the original date of purchase and [3) quote our return authorization number. Repaired or replaced products will be returned to you with shipping charges prepaid. Replacement products may be refurbished or contain refurbished materials. If in our sole discretion, we are unable to repair or replace a defective product, we will refund the purchase price of the product. This warranty will not apply if in our judgment, the product fails due to damage in shipment, handling, storage, accident, abuse or misuse, or if it has been used in a manner not conforming to our product instructions, has been modified in any way, or has any serial number removed or defaced. Repair or attempted repair will void this warranty. Our maximum liability under the terms of this warranty is limited to the purchase price of the product covered by the warranty. The warranty is given under English Law. if any part of this warranty is deemed unenforceable [including any provision in which we exclude our liability to you) the enforceability of any other parts of the warranty will not be affected. These terms do not reduce your statutory rights. For Non-UK please contact Local Luceco Office for details, THESE TERMS AND CONDITIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE,
Eventually, you may want to replace this fitting:
Environmental Protection W.E.E, E IWheelie Bin Symbol for EU ONLY This symbol
is known as the “crossed-out’ wheelie Bin Symbol”. When this symbol is marked
on a product or battery, It means that it should not be disposed of With your
general household waste. Some chemicals contained within electrical/electronic
products or batteries can be harmful to health and the environ ment. Only
dispose of electrical/electronic/battery items in separate collection schemes,
which cater for the recovery and recycling of materials contained within. Your
co-operation is vital to ensure the success of these schemes and for the
protection of the environment,
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>