Orbit BH1G2 B-Hyve Wi-Fi Hub User Guide

: June 5, 2024
: Orbit

Table of Contents

Orbit BH1G2 B-Hyve Wi-Fi Hub
Box Contents
FCC Statement
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Orbit BH1G2 B-Hyve Wi-Fi Hub

Box Contents

Gen 2 Hub
Quick Start Guide

Open the B-have App
Log into your B-have account and go to devices under se˜ings to add the Gen 2 Hub as a new device. The app will walk you through the rest of the process.

NOTE:

For new users, search for “B-have” and download the free Android or iOS app. Create an account to begin timer setup.

Power Your Gen 2 Hub Write down the MAC address: 12-digit alphanumeric code on the back of the hub.

Hub MAC Address:

Plug the Gen 2 Hub into an indoor outlet within range of your B-hyve device and Wi-Fi signal.

NOTE:

Avoid areas where the signal must travel through dirt or thick steel barriers.

Enter Pairing Mode Press the B-hyve bu˜on to enter into pairing mode. Your hub will flash a blue light every 5 seconds.

Hub

Model: BH1G2
Range: 300 ˛ (91 m) without interference
Temperature Operating Range: 32°F-104°F (0-40°C)
Storage Temperature: -4°F to 140°F (-20 °C to 60 °C)
Humidity Operating Range: 0–90%
Input: 100-240V ~ 50/60Hz 0.2A
Output: 5V-1.0A
For Indoor Use Only

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o˙ and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit di˙erent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

IC Statement:

This device contains license-exempt transmi˜er(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. This device meets the FCC and IC requirements for RF exposure in public or controlled environments. The end-user is advised to maintain a distance 20 cm from the timer and any personnel to ensure compliance with RF exposure regulations.

Need Help?
If you encounter a problem, please use the following resources before returning your B-have to the store. Scan the QR Code for access to a full user manual, videos, and more.